Bosch FAP-OC 500Series Use And Care Manual / Installation Instructions - Page 14

Browse online or download pdf Use And Care Manual / Installation Instructions for Washer Bosch FAP-OC 500Series. Bosch FAP-OC 500Series 40 pages. Built-in wall ovens
Also for Bosch FAP-OC 500Series: Installation Instructions Manual (21 pages), Instructions For Use Manual (40 pages), Installation Manual (6 pages), Product Information (40 pages), Installation Manual (28 pages), User Manual (48 pages), User Manual (48 pages), Installation Manual (28 pages), Use And Care Manual (44 pages), Installation Manual (32 pages), Quick Reference Manual (4 pages), Use And Care Manual (27 pages), Installation Manual (24 pages), Installation Manual (32 pages), Use And Care Manual (24 pages), Installation Manual (28 pages), Service Manual (41 pages), Use And Care Manual (21 pages), Installation Manual (32 pages), Service Manual (36 pages), Installation Manual (32 pages), Quick Start And Safety Manual (13 pages)

Bosch FAP-OC 500Series Use And Care Manual / Installation Instructions
Only use the new water supply hose shipped with your
washer. Never use old used hoses.
The water supply hoses must not be kinked, bent, or
pinched causing hose damage or restricting water
flow.
The water supply pressure must be between 14,5 to
145 psi (1 - 10 bar) with a minimum of 2.2 U.S. gallons
(8 liters) of flow per minute. A pressure regulator valve
must be installed if the maximum water pressure is
exceeded.
Make sure the water supply faucet is easily accessible
when the washer is in use. The faucet should be
turned off if the washer is going to be unused for
extended periods of time.
Make sure rubber washers are in place at both ends of
the water supply hose. Missing washers could cause
leaks.
The connection points are under full water pressure.
Turn on the water tap and check for leaks.
Periodically inspect the water supply hose and replace
with a new hose if cuts, kinks or leaks are observed.
Water connection hoses
blue - Cold water-hose
red - Hot water-hose
14
Attach this end to water tap. Hand tighten only.
Attach this end of the hose to the back of the washing
machine as shown in the following pictures. Be sure to
use clamps and route hoses as instructed. Hand
tighten only.
Position hoses as shown when routing hoses to right
side of washer (facing from front