Draper FlexShade Instructions Installation & Operation - Page 3

Browse online or download pdf Instructions Installation & Operation for Projection Screen Draper FlexShade. Draper FlexShade 12 pages. Exterior clutch-operated shade
Also for Draper FlexShade: Installation & Operation Manual (8 pages), Installation Instructions (2 pages), Instructions Manual (12 pages), Installation & Operation Instructions (11 pages), Instructions Installation & Operation (12 pages), Instructions Installation & Operation (16 pages), Instructions Installation & Operation (4 pages), Instructions Manual (7 pages), Instructions Installation & Operation (16 pages)

Print Page
Draper FlexShade Instructions Installation & Operation
Exterior Clutch-Operated FlexShade
FOR SHADES WITH BRACKET INSTALLATION

Section 1 - BRACKET INSTALLATION: Bead Chain Clutch Installation

Caution: Before mounting shades, verify measurements on label provided with shade, and ensure unit is installed at correct width.
Please Note: Installer is responsible for selecting mounting hardware appropriate for site conditions.
BRACKET INSTALLATION:
Please Note: Idler End must be installed FIRST.
1. Mark wall, jamb, or ceiling for placement of mounting brackets and drill small starter hole
2. Place spring-loaded pin into idler bracket, slip notches on clutch into clutch bracket. Press down to lock in place.
Small Universal Brackets
1 "
40mm
2 "
60mm
"
1 "
24mm
30mm
"
24mm
Figure 1A
Large Universal Brackets
2 "
57mm
2 "
73mm
"
24mm
"
24mm
Figure 2A
BRACKET INSTALLATION:
Please Note: Idler End must be installed FIRST.
1. Mark wall, jamb, or ceiling for placement of mounting brackets and drill small starter hole
2. Slide notched pin into idler bracket. Slip retainer clip onto idler end between bracket and roller
3. Install clutch end onto spear on clutch bracket.
2 "
57mm
3 "
83mm
2 "
60mm
Idler
Figure 3A
20# Clutches
Small
Idler
2 x 2
Bracket
(60mm x 56mm)
"
17mm
2 "
56mm
1 "
44mm
Large
Idler
2 x 2
Bracket
(73mm x 56mm)
"
17mm
2 "
56mm
1 "
1 "
44mm
48mm
24# Clutches
3 "
83mm
2 "
70mm
Clutch
2 "
57mm
®
(For shades with Endcap Installation, go to page 6.)
(if necessary)
Idler End
of Roller
1.
Figure 1B
Idler End
of Roller
1.
Figure 2B
(if necessary)
(Fig.3B)
Idler
Idler End
Bracket
of Roller
1.
in mounting surface.
Clutch
Clutch Bracket
2.
in mounting surface.
24 lb Clutch
45°
Figure 3B
page 3 of 12
Clutch Bracket
2.
Clutch Bracket
2.