Draper M Series Installation & Operating Instructions - Page 2

Browse online or download pdf Installation & Operating Instructions for Projection Screen Draper M Series. Draper M Series 2 pages. Manual screen with revolutionary case design with autoreturn
Also for Draper M Series: Specifications (1 pages)

Print Page
Draper M Series Installation & Operating Instructions
Access/Series M by Draper
Locate the roller/fabric assembly and remove the retaining clip and flat washer
from the idler end pin, and remove retaining clip from the spear. Remove
brackets from roller.
NOTE: This may require two people to perform safely. Raise the roller/
fabric assembly up into the screen housing and engage the spear of the roller
completely into the spear mounting bracket. If roller is 1
closest to the edge of the bracket. If roller is 2
center slot.
Install the retaining clip on the spear, locking spear and bracket together.
While supporting the idler end of the roller, slide the idler end mounting
bracket toward the roller. Insert the roller pin into the nylon bushing on the
idler end mounting bracket.
The roller idler pin needs to go through the idler bracket far enough to allow
the washer and retaining clip to be reinstalled on the pin. Failure to replace
the washer and retaining clip as shown could result in the separation of the
roller from the brackets.
Securely tighten the four set screws on the idler end mounting bracket.
Reinstall the bottom access panel as previously described.
Spring Roller/Fabric Removal
Reverse the instructions above "Spring Roller/Fabric Installation" for removal
of the unit.
Mounting hardware supplied by others
Engagement bracket (one on each end
of the bottom access panel) clicks into
place with the ball detent on each endcap.
5
1
/
"
1
2
/
"
32
8
If you encounter any difficulties installing or servicing your Access/Series M
screen, call your dealer or Draper, Inc., in Spiceland, Indiana, (765) 987-7999;
fax (765) 987-7142; or e-mail [email protected].
3
/
" diameter, use slot
4
1
/
" or 3" diameter, use the
4
Case Dimensions
3
1
/
"
16
4
23
/
"
32
Retaining
clip
5
6
/
"
8
7
3
/
"
16
7
7
/
"
16
3
3
/
"
4
Access
3"
panel
8"
Overall
flange width
Page 2 of 2
Washer
Nylon bushing
Roller mtg. brkt.
Roller
Use this slot on 2¼" and 3" dia. rollers
Use this slot on 1¾" dia. roller
Overall case length
Mounting brackets slide
left and right as needed.
Viewing
Surface
Roller pin
Retaining clip