Draper Onyx Assembly/Mounting Instructions
Browse online or download pdf Assembly/Mounting Instructions for Projection Screen Draper Onyx. Draper Onyx 2 pages. Permanently tensioned projection screen
Also for Draper Onyx: Assembly/Mounting Instructions (2 pages), Assembly/Mounting Instructions (2 pages)
Print Page
Onyx Permanently Tensioned Projection Screen by Draper
➀ Read instructions through completely before proceeding.
➁ Follow instructions carefully. Installation con trary to instructions
invalidates warranty.
➂ Screen should be accessible for complete removal should fabric
become damaged or should other ser vice be required.
➃ Screen should be installed level (using a carpenter's level).
➄ Nothing should be fastened to screen frame or viewing surface.
➅ Make sure you have received all parts (see parts list below and
exploded diagram on page 2).
➆ Tools Required: Medium (#2) Phillips screwdriver (6" or greater shaft
length suggested). Optional tools: Flat blade screwdriver or small
putty knife.
➇ Installer is responsible for providing appropriate hardware for mounting.
NOTE: Screen has been thoroughly inspected and tested at factory and
found to be operating properly prior to shipment.
Onyx—Hardware and Parts List
Frame Extrusions - 4
Z-Brackets - 2
Surface Retention
Extrusions- 4
#10-24 fasteners - 8
Frame Preparation
➀ Clean area and place frame assembly pieces face down. Insert plastic
corner pieces into ends of aluminum frame extrusions as indicated in
Figures 1 through 4. Secure each corner to each frame extrusion by
threading one #10-24 fastener through hole in plastic corner and into
rounded slot in aluminum frame extrusion.
Copyright © 2005 Draper Inc.
Assembly/Mounting Instructions
Caution
Frame Corners - 4
Plastic Tubing - 4
Viewing Surface - 1
Figure 1
Form Onyx_Inst05
➁ Secure corner pieces to aluminum frame extrusions with four (4) remaining
fasteners. Check to verify that all four (4) plastic corners are secure to
aluminum frame extrusion lengths and all eight (8) fasteners are tight (see
Fig. 5).
Please Note: It is not necessary to over-tighten fasteners.
If you encounter any diffi culties installing or ser vic ing your Onyx
screen, call your dealer or Draper, Inc., Spiceland, Indiana,
(765) 987-7999; [email protected].
Printed in U.S.A.
Figure 2
Figure 3
Figure 4
Figure 5
(Continued on Page 2)