Bosch Vision 800 Series Service Manual - Page 23

Browse online or download pdf Service Manual for Washer Bosch Vision 800 Series. Bosch Vision 800 Series 43 pages. Gas slide-in ranges
Also for Bosch Vision 800 Series: Instructions For Use Manual (40 pages), Dimensions And Specifications (2 pages), Installation Manual (6 pages), Installation Instructions Manual (28 pages), Service Manual (36 pages)

Print Page

58300000202443_ARA_EN_C

6. Remove the screw in the bottom center of the panel, which

secures the panel to the carrier directly behind it.

7. Separate the carrier from the front panel assembly.

Figure 27 Front panel assembly (top) separated from carrier (bottom) with display module attached

8. Reassemble the control panel using the new front panel

service assembly.

9. Reattach the control panel, restore power, and test operation.

6.4.2

Replacing the Display Module

The display module is secured to the control panel carrier with

four nylon spacers (standoffs).

Figure 28 Display board secured to carrier with the carrier's 4 metal tabs

1. Remove the front panel as described in Replacing the Front

Panel Service Assembly section.

This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.

JANUARY 2018

2. Using pliers, gently straighten each metal tab so that they align

with the slots in the display board, then lift the board off the

tabs.

3. Position the new display board so that the slots in the board

align with the four metal tabs, and firmly push the board

downward until it is securely in place.

4. Slightly re-twist each of the four metal tabs.

5. Reassemble the control panel.

6. Reattach the control panel to the side trim and vent trim.

7. Restore power and test operation.

6.5

Cavity Lights

Each 30" oven cavity uses one incandescent 40W appliance bulb with

a standard Edison base. Each 27" oven cavity uses two 25W

incandescent bulbs (25WPRE14), with a European base.

Replacement bulbs may be purchased locally.

Figure 29 Left: 25W bulbs used in 27" ovens

On double ovens, lights are either on or off in both cavities; it is not

possible to operate cavity lights independently.

The cavity light(s) can be turned on in two ways: by pressing Oven

Light or opening the oven door. If Oven Light had not been pressed to

turn light(s) on prior to opening the oven door, the light(s) will turn off

when the door is closed. If Oven Light had been pressed to turn

light(s) on prior to opening the oven door, the light(s) will remain on

after the door is closed.

In other words, the Oven Light switch overrides the door.

1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614

Service Manual for Bosch 800 Series Built-in Wall Ovens

| Right: 40W bulb used in 30" ovens.

Page 23 of 43

800 944-2904