Bosch Vision 800 Series Service Manual - Page 15

Browse online or download pdf Service Manual for Washer Bosch Vision 800 Series. Bosch Vision 800 Series 36 pages. Gas slide-in ranges
Also for Bosch Vision 800 Series: Instructions For Use Manual (40 pages), Dimensions And Specifications (2 pages), Installation Manual (6 pages), Service Manual (43 pages), Installation Instructions Manual (28 pages)

Print Page
Bosch Vision 800 Series Service Manual
58300000194725 ARA EN B
NOTICE
It may be necessary to use a tool, such as a screwdriver, to gently
pry the upper part of the hinge lever away from the housing. Take
care to avoid scratching the porcelain.
3. Partially close the oven door until it is open about 7" and
catches on the hinge-stop levers.
4. Using both hands, lift door upward and outward to disengage
the hinges from the hinge receiver slots.
5. Set the door aside on a protected flat surface.
To reinstall the door...
1. Hold the door firmly in both hands and position the hinges in
the hinge receivers, so that the slot in the base of the hinge (A)
engages with the hinge receiver (B).
Figure 8 Position the hinge in the hinge slot
2. Tilt the door inward and slide the hinges into place; the hinges
should catch and the door should remain in place.
3. Open door fully to expose the hinge levers and hinge receiver
slots.
4. Flip the right and left hinge levers forward until they are fully
closed.
Copyright by BSH Home Appliances Corporation
This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.
MAY 2016
Figure 9 Closing hinge lever
5. Open and close the door carefully to confirm that the door is
installed correctly and securely, and does not appear to be
askew when closed.
6. Carefully close and open door to check operation.

6.1.3 Replacing Hinges

The hinges are offered in service kits which include both the RH and
LH dual-spring hinges; always replace hinges in pairs.
To access the hinges...
1. Remove the door as described in the Removing and
Reinstalling the Door section.
2. With the porcelain-coated door liner up, remove the two
screws on each side of the door liner.
3. Remove the screws along the bottom of the door assembly.
Figure 10 Removing door liner screws
1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614
Service Manual for Bosch 800 Series Gas Slide-in Ranges
Page 15 of 36
800 944-2904