Bosch WAJ Series Instruction Manual And Installation Instructions - Page 38
Browse online or download pdf Instruction Manual And Installation Instructions for Washer Bosch WAJ Series. Bosch WAJ Series 40 pages.
Print Page
Faults and what to do about them
en
Faults
The spin result is not sat-
isfactory.
Laundry is wet/too damp.
The spin cycle runs sev-
eral times.
The program is taking
longer than usual.
The length of the program
changes during the wash
cycle.
Residual water in the
care-product compart-
ment i .
Odours in the washing
machine.
Foam is leaking from the
detergent drawer. Foam
is visible in the drum
Loud noises, vibrations
and machine "move-
ment" during the spin
cycle.
* depending on the model
38
Cause/Remedy
Not a fault – the unbalanced load detection system has interrupted the spin
■
cycle because the laundry is unevenly distributed.
Distribute small and large items of laundry evenly in the drum.
Easy-Iron (depending on the model) selected? ~ Page 25
■
Is the selected speed too low?
■
You may run the program Spin/Drain to spin the laundry again.
■
Not a fault – the unbalanced load detection system is adjusting an imbalance.
The water pressure is too low, r lights up ~ Page 36
■
Not a fault – the unbalanced load detection system is adjusting an imbal-
■
ance by repeatedly distributing the laundry in case imbalances have been
detected.
Not a fault – the foam detection is active – a rinse cycle has been switched
■
on in case foam has been detected.
Laundry is more than defined program in this case deselect the speed per-
■
fect
Not a fault – the program sequence is optimised for the specific washing
■
process according to the load and the type of textiles. This may change the
length of the program shown in the display panel.
The water pressure is low - the washing program will take longer as usual
■
Not a fault – the effect of the care product is not affected.
■
Clean the insert if necessary.
■
Depending on the model, run the Cottons 60 °C or i Cottons 90 °C program
without laundry.Add washing powder or a detergent containing bleach.
Note:
To prevent foaming, only use half the amount of detergent recommended
by the detergent manufacturer. Do not use detergents designed for wool or del-
icates.
The Å symbol lights up in the display panel.
Have you used too much detergent? Use less detergent in the next wash
■
cycle.
Mix one tablespoon of fabric softener with 1/2 litre of water and pour it into
■
compartment II (not suitable for outdoor clothing, sportswear or items
stuffed with down).
Right front loading detergent need to be used for front loading appliance.
■
Is the appliance aligned? Align the appliance. ~ Page 13
■
Are the appliance's feet fixed? Secure the appliance's feet. ~ Page 13
■
Have the transport locks been removed? Remove the transport locks.
■
~ Page 10