Draper 83611 Instructions Manual - Page 7

Browse online or download pdf Instructions Manual for Power Tool Draper 83611. Draper 83611 20 pages. Biscuit jointer
Also for Draper 83611: Manual (20 pages)

Print Page

HEALTH & SAFETY INFORMATION

g) If devices are provided for the connection of dust extraction and collection facilities,

ensure these are connected and properly used. Use of dust collection can reduce dust

related hazards.

4) Power Tool Use And Care

a) Do not force the power tool. Use the correct power tool for your application. The

correct power tool will do the job better and safer at the rate for which it was

designed.

b) Do not use the power tool if the switch does not turn it on and off. Any power tool

that cannot be controlled with the switch is dangerous and must be repaired.

c) Disconnect the plug from the power source and/or the battery pack from the power

tool before making any adjustments, changing accessories, or storing power tools.

Such preventive safety measures reduce the risk of starting the power tool

accidentally.

d) Store idle power tools out of the reach of children and do not allow persons

unfamiliar with the power tool or these instructions to operate the power tool.

Power tools are dangerous in the hands of untrained users.

e) Maintain power tools. Check for misalignment or binding of moving parts, breakage

of parts and any other condition that may affect the power tools operation. If

damaged, have the power tool repaired before use. Many accidents are caused by

poorly maintained power tools.

f) Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp

cutting edges are less likely to bind and are easier to control.

g) Use the power tool, accessories and tool bits etc., in accordance with these

instructions, taking into account the working conditions and the work to be

performed. Use of the power tool for operations different from intended could result

in a hazardous situation.

5) Service

a. Have your power tool serviced by a qualified repair person using only identical

replacement parts. This will ensure that the safety of the power tool is maintained.

5.2 ADDITIONAL SAFETY INSTRUCTIONS FOR SAW BLADES

Safe Working Practice

Maximum speed

–

The maximum speed marked on the tool shall not be exceeded. Where stated, the speed

range shall be adhered to.

Circular saw blades

–

Circular saw blades, the bodies of which are cracked, shall be scrapped (repairing is not

permitted).

–

Composite (tipped) circular saw blades, where the tip dimension is reduced to less than

1mm, shall be taken out of service.

One piece tools

–

Tools with visible cracks shall not be used.

Fastening of tools and tool parts

–

Tools and tool bodies shall be clamped in such a way that they shall not loosen during

operation.

–

For tools with friction lock the positioning aid or setting gauge provided by the

manufacturer shall be used to maintain radical and axial cutter projections.