Draper CIW12VD Original Instructions Manual - Page 9
Browse online or download pdf Original Instructions Manual for Power Tool Draper CIW12VD. Draper CIW12VD 20 pages.
Print Page
5.2 ADDITIONAL SAFETY INSTRUCTIONS FOR IMPACT WRENCH
Warning!
1) Safety instructions for all operations
a) Wear ear protectors. Exposure to noise can cause hearing loss.
b) Brace the tool properly before use. This tool produces a high output torque and without
properly bracing the tool during operation, loss of control may occur resulting in personal
injury.
c) Hold the power tool by insulated gripping surfaces, when performing an operation
where the fasteners may contact hidden wiring or its own cord. Fasteners contacting a
"live" wire may make exposed metal parts of the power tool "live" and could give the
operator an electric shock.
5.3 SAFETY INSTRUCTIONS FOR MAINS POWERED CHARGERS &
BATTERY PACKS
Chargers
–
The charger is for indoor use only.
–
Prior to plugging the charger in to the supply, check that the plug, cable and charger casing
are in good condition. If any are damaged, have the defective part(s) replaced immediately by
a suitably qualified person.
–
Only use a correctly rated mains outlet to provide power, do not plug into site generators, attach
to engine generators or D.C. sources. Do not use a mains socket outlet that is not switched.
–
Use the correct Draper charger in conjunction with it's corresponding battery pack (consult the
Draper website for more information or to find your local stockist).
–
Do not charge any other batteries with Draper chargers. Any other application is considered
misuse.
–
Do not attempt to charge battery packs that are too hot (over 30°C) or too cold (under 5°C),
if these conditions apply set the battery pack aside to "normalise" before proceeding with the
charging operation.
–
Set up the charger and cable in a safe place where it won't be knocked, tripped over, stepped
on, etc. and where it is well ventilated. Make sure the ventilation slots in the charger case are
not obstructed.
–
Inspect the battery pack for damage, if it is undamaged, plug it into the charger, ensuring the
correct orientation.
–
Switch the charger on and check that the correct indicators illuminate, allow the battery pack
to charge (see the specific instructions for your charger). Once charging is complete, switch
the charger off, disconnect from power supply, remove the battery pack and store.
– 9 –