Draper D16/16F Instructions Manual - Page 6

Browse online or download pdf Instructions Manual for Power Tool Draper D16/16F. Draper D16/16F 20 pages.

Print Page

1. This drill press is intended for use only

with drill bits. The use of any other

accessories may be hazardous.

2. CHECK to see that the drill bit is

securely locked in the chuck.

3. CORRECT DRILLING SPEEDS

Important factors which determine the

best speed to use in any drill press

operation are:

(a) The smaller the drill the greater the

required r.p.m. (revolutions per

minute)

(b) In soft materials the speed should be

higher than for hard materials.

4. MAKE sure that the chuck key is

removed before turning on power.

Carefully unpack the bench drill and all loose items from the carton. Illustrated below

is the bench drill and all loose items. NOTE: Some loose parts may be packed inside the

pulley cover.

Fig.1.

Now referring to Fig.1. carefully check that all the parts are present.

Please contact the stockist where your purchase was made if you have any enquiries, eg

problems with assembly, apparent missing/damaged parts, help with accessories

available or technical advice or alternatively call the Draper Helpline on (023) 8049 4344.

ADDITIONAL SAFETY RULES FOR

DRILL PRESSES

UNPACKING AND CHECKING CONTENTS

5. CHECK to see that the chuck is

securely fastened to the spindle.

6. CAUTION

When practical, use a vice or clamps to

secure workpiece to avoid workpiece

rotating with the drill bit.

7. SECURE the tool to a workbench or

floor. If during operation there is any

tendency for the drill press to tip over,

slide or walk on the supporting surface,

the drill base must be secured to the

supporting surface with fasteners

through the holes located in the drill

press base.

8. For your safety DO NOT wear gloves

when operating a drill press.

- 5 -