Draper SDS+ Instructions Manual - Page 8

Browse online or download pdf Instructions Manual for Drill Draper SDS+. Draper SDS+ 12 pages. Sds+ rotary hammer drills

Print Page

INSERTING TOOLS

WARNING

Disconnect the plug from the power supply

socket before replacing drill bits or tools.

The tool holder ✰✌ clamps drilling and chiselling

tools without using a chuck key.

Pull back the unlocking collar ✳✌. Insert the tool

while turning into the tool holder ✰✌ until it

latches. Release the unlocking collar. Check

whether the tool is firmly seated. Fig.5.

IMPORTANT

Always clean and lightly grease the tool shaft

before inserting into the chuck.

Take care that the dust protection cap ✱✌ is not

damaged. Fig.5.

Replace damaged dust protection caps

immediately or gearbox problems will ensue !

REMOVING TOOLS

Slide the unlocking collar ✳✌ to the rear and pull

out the tool. Fig.5.

ADJUSTING THE CHISEL (PHD624VC ONLY)

Set the gear selector/rotation stop switch ✬✌ to an

intermediate position. The chisel can now be turned

by hand to the required working position. Fig.3.

Return the gear selector/rotation stop switch ✬✌

to the initial position

automatically as soon as it is radially loaded by

the working or chiselling process.

SLIP CLUTCH

If the drill bit becomes jammed or gets caught,

the clutch will slip.

Remove the load from the machine immediately

by pulling back the drill bit.

Always hold the machine tightely with both hands

and assume a secure stance.

Do not apply too much pressure. The performance

is not increased in this manner.

The most effective method for chiselling is to

break out only small pieces of material.

PHD624VC only.

DRILL CHUCK (ACCESSORY)

For drilling work in metal, wood and plastic with

drills that have normal shafts, a drill chuck (13mm

max. chuck opening) is available. The drill chuck

is mounted on the adapter (accessory) for

screwdriver bits. All common drill chucks ✵✌ with

⁄

" x 20 UNF internal threads (13mm max. chuck

opening) can be used (Fig.6).

FITTING THE CHUCK

Clean the threads of the drill chuck ✵✌

(accessory) and the adapter ✴✌ (accessory).

Fig.6.

Screw the drill chuck onto the adapter ✴✌ and

lock the adapter ✴✌ in the same manner as a drill

in the tool holder ✰✌. To tighten a keyless drill

chuck, set the gear selector/rotation stop switch

✬✌ (Fig.3) temporarily to position

OPERATION & USE

. The chisel latches

Fig.5.

Fig.6.

✴✌

✵✌

IMPROPER USE

The functions and use of this tool are those

exclusively indicated in this manual.

ANY OTHER USE OF THE TOOL IS

EXPLICITY FORBIDDEN.

- 7 -

✳✌

✱✌

✰✌

SDS-PLUS