Draper STORMFORCE CD144LISF Instructions Manual - Page 11
Browse online or download pdf Instructions Manual for Drill Draper STORMFORCE CD144LISF. Draper STORMFORCE CD144LISF 20 pages. 14.4v li-ion cordless rotary drill
Print Page
8.
BASIC CORDLESS ROTARY DRILL OPERATIONS
8.1 BATTERY CHARGING – FIGS. 1 – 2
To charge the battery pack
removed from the drill.
(i) To release the battery pack, press down on the
battery release button
front of the battery pack and gently pull the
battery pack away from the housing (Fig.1).
(ii) Slide the charger connector
connection block of the battery pack
then the charger's three pin plug into a 230V
electrical socket.
(iii) The red LED on the charger will illuminate solid
and the green LED will extinguish to show that
the battery is charging.
The battery will be fully charged after the 3-5 hour
charging period. The red LED will no longer illuminate
and the green LED will illuminate solid.
The battery pack and charger can then be seperated
and removed from the 230V supply.
To refit the battery pack to the drill, push firmly until
the battery pack locates and clips into place.
Warning: Do not exceed charging period this could
damage the battery. Overcharging the battery (more
than six hours) could damage the battery cells.
Note: The battery was discharged after manufacturing
and will therefore require five to ten charges/discharges before it reaches its full capacity.
Do not expose either the drill or charger to rain or water.
8.2 DUST AND SWARF
A correctly fitted dust mask, suitable for the activity and in accordance to the relevant
standard must be worn.
Swarf produced by metal drilling is extremely sharp. Take precautions when clearing swarf.
The burr left on the hole is also sharp and should be removed with a suitable tool.
Always wear safety goggles.
Warning: Drill bit will be hot after use.
, it must first be
located on the
onto the
and
FIG.1
FIG.2
11