Draper 60606 Instructions Manual - Page 4

Browse online or download pdf Instructions Manual for Air Compressor Draper 60606. Draper 60606 12 pages. Oil free compressors

Print Page

CONNECTING THE COMPRESSOR TO THE POWER SUPPLY:

To eliminate the possibility of an electr ic shock your machine has been f itted with a

BS approved, non rewireable moulded plug and cable which incorporates a fuse, the

value of which is indicated on the pin f ace of the plug. Should the fuse need to be

replaced an

. The fuse cover is detachable, never use the plug with the co ver omitted. If a

replacement fuse cover is required, ensure it is of the same colour as that visib le on the

pin face of the plug (i.e. red). Fuse covers are available from your Draper Tools stockist.

If the fitted plug is not suitable, it should be cut of f and destroyed. *The end of the

cable should now be suitably prepared and the correct type of plug f itted. See below.

*WARNING:

A plug with bare flexible wires exposed is hazardous if engaged in a live power socket

outlet.

WARNING: THIS APPLIANCE MUST BE EARTHED.

Green and Yellow - Earth, Blue - Neutral, Brown - Live.

As these colours may not correspond with the coloured markings identifying the

terminals in your plug, proceed as follows.:

The wire which is coloured green and yellow must be connected to the terminal in the

plug which is marked with the letter 'E' or b y the earth symbol

green and yellow.

The wire which is coloured blue must be connected to the terminal w hich is marked

with the letter 'N' or coloured black or blue.

The wire which is coloured brown must be connected to the terminal w hich is marked

with the letter 'L' or coloured red or brown.

N.B. Three phase machines must be connected b y a qualified electrician.

CONNECTING YOUR MACHINE TO THE POWER SUPPLY (110V)

To eliminate the possibility of an electric shock your machine has been fitted with a

BS approved, rewireable plug and cable. If the fitted plug is not suitable, it should be

removed, the end of the cable should be suitably prepared and the correct type of plug

fitted. See below.

WARNING: THIS APPLIANCE IS DOUBLE INSULATED.

Single phase 110 volt machines must be connected using the relevant coding and

matching the colour of the flexible cable to that of the plug. The procedure is as follows:

1. Connect brown coloured core to plug terminal marked letter 'L' (live).

2. Connect blue colour core to plug terminal marked letter 'N' (neutral).

EXTENSION LEAD CHART:

Extension lead sizes shown assure a voltage drop of not more than 5% at rated

load of tool.

Ampere rating

(on Name plate)

Extension Cable Length

7.5m

15m

22.5m

30m

45m

POWER SUPPLY

approved BS1362 fuse must be used of the same r ating, marked thus

0.75 0.75

0.75 1.25

Wire Size mm 2

- 3 -

or coloured green or

10 13

1.0

1.25

1.0

1.5

1.0

1.5

1.25

1.5

2.5