Draper 02519 Manual - Page 15

Browse online or download pdf Manual for Grinder Draper 02519. Draper 02519 20 pages. 230v router
Also for Draper 02519: Manual (20 pages)

Print Page

BASIC ROUTER OPERATIONS

Release the plunge lock lever and raise the router

back to full height. Rotate the turret round several

positions and the router is set up ready to begin

work.

When beginning to cut, plunge the cutter slowly to

the first depth and proceed with the cut. Take a

second pass at the next step down on the turret and

continue until the full depth is achieved.

Regulate the depth of the cut and speed of feed to

ensure no strain is put on to the cutter or motor,

however if the speed is too slow, burn marks may

appear on the workpiece.

Note: The direction of rotation is marked on the

machine housing above the spindle stop

mechanism. Travelling along a workpiece in the

wrong direction will cause the bit to pull and bounce,

leading to a poor finish and possible damage.

− If, after the full depth has been routed, further

material removal is necessary lock the router in

the plunged position.

− Rotate the fine height adjustment control (5).

− Turning the fine adjustment anti-clockwise will

increase the plunge depth. One complete turn is

equivalent to 1mm plunge depth. When set, take

another pass along the cut.

Note: Remove the plug from the socket before

carrying out adjustment, servicing or maintenance.

9.4

PARALLEL GUIDE ROUTING –

FIG. 9

Ensure the edge along which the guide is going to

travel is smooth and true as any inconsistencies will

translate into the cut.

•

See section 8.1 PARALLEL GUIDE FENCE on

page 12 for assembly instructions.

When using the parallel guide an even pressure

should be applied to each face except on a leading/

trailing edge of a workpiece. When leading on to a

workpiece apply the pressure to the forward face

until both faces are on. When trailing off a workpiece apply the pressure to the rear face until the

cut is complete.

9.5

TEMPLATE FOLLOWER – FIG. 10

For detailed information on templates refer to a routing/woodworking book.

− Lay the template follower (16) into the recess. Ensure the template follower faces downward

and secure with the two countersunk screws (16.1).

Warning! Whilst this router is capable of cutting kitchen worktops, it should be noted that this is

not a professional machine and therefore its tolerances and performance are not as accurate as a

professional machine.

FIG.

(16.1)

Stock No. 02520

FIG.

– 15 –

Stock No. 02519

(16)

(19)