Draper 02520 Manual - Page 14

Browse online or download pdf Manual for Grinder Draper 02520. Draper 02520 20 pages. 230v router
Also for Draper 02520: Manual (20 pages)

Print Page

ASSEMBLING THE BENCH GRINDER

8.4

ATTACHING THE SPARK

DEFLECTORS – FIG.3

− Attach the left and right hand spark deflectors

using the fittings from group's (B) and (C) shown

in 7.2 WHAT'S IN THE BOX section on page 12.

− Attach the spark deflectors using the two bolts

(B.1) and medium size washers (B.2) as shown

in Fig.3.

− When fitted, adjust the spark deflectors so that

there is approximately a 1.5mm (1⁄16") gap

between the surface of the grinding wheels and

spark deflectors.

8.5

ATTACHING THE EYE SHIELDS –

FIG.4

− Attach the eye shields using the fittings from

group (D) shown in 7.2 WHAT'S IN THE BOX

section on page 12.

− Place the eye shield frame (D.1) over the eye

shield (D.2) fasten the two parts together using

the long screws, washers and nuts, as shown in

Fig.4. Note: Do not overtighten as the eye shield

may crack.

− Assemble the other eyeshield in the same way.

− Insert the shortest end of the mounting rod (D.3)

into the hole in the shield frame (D.1) (Fig.5).

− Tighten the nut and round headed bolt which are

located in the centre of each of the eye shield

mounting frames.

− To fit the eye shields to the bench grinder attach

clamp (D.4) to the wheel guard using lock knob

(D.5) large star washer and large washer as

shown in Fig.6. Insert mounting rod into the

clamp, position as required and tighten lock knob.

The eye shield is fully adjustable. It can be

adjusted by either loosening the lock knob and

moving the rod or by moving the eye shields.

(B.1)

FIG.

(D.3)

FIG.

– 14 –

(B.2)

(D.2)

(D.1)

(D.4)

(D.5)

(7)