Draper Dual Roller FlexShade NEXD Installation & Operation Instructions - Page 7
Browse online or download pdf Installation & Operation Instructions for Indoor Furnishing Draper Dual Roller FlexShade NEXD. Draper Dual Roller FlexShade NEXD 10 pages. Heavy-duty, clutch-operated window shade
Print Page
Dual Roller FlexShade
Section 5 - Spring Assist Option
Figure 6-A
Safety Screws
(RETAIN FOR LATER)
Figure 6-B
Section 6 - Safety Brackets
PLEASE NOTE: Under certain extreme circumstances, the Idler Endcap of the FlexShade
to hold the shade roller pins in place. This kit contains
REMEMBER: For correct fit, endcap covers MUST be installed! Ensure that the endcap covers are properly mounted to the unit.
Figure 7-A
e r
I d l
X D
a p
N E
d c
E n
NEXD
®
(Idler End)
Caution: The retaining clip must be installed around the idler-end shaft as shown to prevent the roller
assembly from moving left or right during operation, and to ensure that the spring-loaded shaft does not
retract into the mechanism in case of a bearing failure.
1.
Remove the safety screw and slide from the top idler endcap.
Retain these pieces for later
Slide
(RETAIN
2.
Install the Top Roller Assembly
FOR
LATER)
clutch
idler end spear up into the receiver. If necessary, compress the
spring-loaded spear.
3.
Install the Bottom Roller Assembly
onto clutch
Slide the idler end spear up into the receiver. If necessary,
compress the spring-loaded spear.
4.
Replace Slide and Safety Screw.
Place into groove at an angle, slide up,
and make sure the bottom of the slide
is hooked into the Receiver
(Fig. 6-A, reversed)
5.
NOTE:
Retaining Clip
Test shade to ensure that roller is
has extrusion to fit
into slots on shaft.
level and operating properly.
If not, adjust idler leveling screw with
3mm Hex Wrench
upon request when ordering shade.
necessary
brackets to prevent shades from disengaging with the idler endcap and falling.
IF FASCIA HAS BEEN ORDERED WITH THIS SHADE: Fascia
N E
X D
C l u
E n d
t c h
c a p
(Fig. 6-A)
, then swing the idler end into place. Slide the
(see Section 4)
, then swing the idler end into place.
(see Section 4)
.
, available
(Fig. 6-C)
Dual Roller NEXD may fail, due to the limitations of the detents designed
®
on both Safety Brackets. If endcap covers are received but not installed, Brackets may be
positioned too far apart and can prevent fascia from fitting securely on the brackets.
Installer
must
either: Add plastic endcap covers to clutch and idler,
loosen the screws on either Idler End or Clutch End
endcap
inward until fascia is firmly seated on the bracket notches.
(s)
page 7 of 10
.
. First, install tube onto
(Fig. 6-B)
. First, install tube
(Fig. 6-B)
MUST
seat in the notches
(or both)
Figure 7-B
SPRING ASSIST
OPTION
N E X
h S
w i t
Figure 6-C
OR
, AND
move
a p
n d c
N E
r E
i s t
d l e
A s s
D I
E
n g
p r i
i o n
O p t