Draper FlexShade Instructions Installation & Operation - Page 6

Browse online or download pdf Instructions Installation & Operation for Indoor Furnishing Draper FlexShade. Draper FlexShade 16 pages. Exterior clutch-operated shade
Also for Draper FlexShade: Installation & Operation Manual (8 pages), Installation Instructions (2 pages), Instructions Manual (12 pages), Installation & Operation Instructions (11 pages), Instructions Installation & Operation (12 pages), Instructions Installation & Operation (16 pages), Instructions Installation & Operation (4 pages), Instructions Manual (7 pages), Instructions Installation & Operation (12 pages)

Print Page

FlexShade

Section 5 - Direct Mounting to Ceiling or Wall

(Alternate Installation Method)

NOTE: This step requires removing Fascia and Roller Assembly.

See Section 3 - Removing Roller Assembly and Section 4 - Removing Fascia

Replace Operator End

of Roller Assembly.

Replace Crank

Crank-Operated ZIP

W A

U N

M O

L E S

H O

Using the tabs on the endcap as a spacing guide, drill

pilot holes through both ends of the Headbox as

applicable for ceiling or wall mounting.

Please Note: Do not drill pilot holes further than 1.5 inches

from ends of the headbox.

L L

T I N

(Page 5)

Attach to mounting surface

using appropriate fasteners.

Please Note: Installer is responsible

for selecting mounting hardware

appropriate for site conditions.

Replace Idler Mounting Gudgeon

on Idler End of Roller Assembly.

Replace Quick

Release Pin.

Proceed to Section 6 -

Installing Side Channels:

Wall or Ceiling

Mounted Shade.

page 6 of 16