Draper FlexShade NEXD Instructions Installation & Operation - Page 6

Browse online or download pdf Instructions Installation & Operation for Indoor Furnishing Draper FlexShade NEXD. Draper FlexShade NEXD 8 pages. Clutch-operated small and large hardware
Also for Draper FlexShade NEXD: Installation & Operation Instructions (6 pages), Instructions Manual (8 pages), Instructions Installation & Operation (8 pages), Instructions Installation & Operation (10 pages), Instructions Manual (12 pages)

Print Page

Bottom-Up FlexShade

Small and Large Hardware

Section 9 - Bottom Roller Assembly

1. Slide the Bottom Roller Assembly into the brackets, spear-end first

Warning: The triangular shaped arrow on the end of the device MUST be pointing UP when installed

"lock" during operation. Raising the hem bar approximately 1/4-turn will "un-lock" the device, providing constant tension on the fabric panel.

Please Note: Ensure that the hem bar cannot move

2. Install the cotter pin through the fabric roller idler bracket to secure the roller

Warning: Do NOT trim draw cables until Section 11, Step 11.

Caution: Starting locations of the Cable Attachment Studs are provided by Draper

shade. Although these locations can be adjusted, the installer must ensure that any

adjustments do not cause the hem bar to run into the brackets, possibly damaging the unit.

1. Carefully pull one end of the draw cable through one of the Draw Cable Pulleys, then behind

the Take-Up roller.

2. Wrap the cable 1 1/2 revolutions around the tube.

3. Grip the end of the draw cable between the Cable

Attachment Stud and roller tube, then tighten the

Cable Attachment Stud.

4. Pull the other side of the draw cable through remaining

Draw Cable Pulley, then behind the Take-Up roller.

5. Pull the hem bar up so that the fabric retraction device

"unlocks."

Warning: DO NOT allow Hem Bar to move around

the roller.

Please Note: Both ends of Draw Cable must have 1½

revolutions around the operator roller when the hem bar

is at its lowest possible position.

NEXD,

(Fig. 9)

around the roller until the installation is complete.

(counterclockwise)

(Fig. 9)

Figure 9

(Section 8, Fig. 8-A)

. Bend one leg of the cotter pin down to lock it into place.

with each

Figure 10

page 6 of 8

to ensure that the mechanism will not