Draper FlexStyle MO Installation & Operation Instructions - Page 5

Browse online or download pdf Installation & Operation Instructions for Indoor Furnishing Draper FlexStyle MO. Draper FlexStyle MO 8 pages. Motor operated window shades with low-profile decorative brackets

Print Page
Motorized FlexStyle

Section 3 - Removing Bracket Covers

Please Note: The Cover Removal Tool
1.
Grasp the flat end of the bracket.
(Motor Bracket shown.)
2.
Slip the small
curved end of
the tool under
the curved end
of the bracket.

Section 4 - Electrical Connections

Shade operates on 110-120V, 60 Hz. current. Shade is shipped with internal wiring complete and control switch
supplied with a 6'
cable lead. Wire to connect shade to switch
(1.82m)
Connections should be made in accordance with attached wiring diagram, and wiring should comply with national and local electrical codes.
Caution: DO NOT wire motors in parallel without written permission from Draper.
Caution: All operating switches should be "off" before power is connected.
Please Note: For low-voltage wiring requirements, Draper recommends consulting with a professional low-voltage electrical
contractor. It is very important that shielded and stranded CAT 5 cable be used to prevent any electrical interference.
TM
(Must be ordered separately.)
is available if bracket covers need to be detached for any reason.
(Part Number C202.053)
, and switch
(es)
3.
Pull off Bracket
Cover.
(A)
4.
Pull off Bracket
Cap.
(B)
to power supply, should be furnished by installer.
(es)
page 5 of 8
fully boxed, and standardly
(es)