Draper FlexStyle MOZ Installation & Operation Instructions - Page 6

Browse online or download pdf Installation & Operation Instructions for Indoor Furnishing Draper FlexStyle MOZ. Draper FlexStyle MOZ 8 pages. Motor operated window shades with low-profile decorative brackets

Print Page

Motorized FlexStyle

Section 5 - RF Remote Programming Instructions

Please Note: The motor ships with no programming. Follow these instructions to program unit to the desired transmitter.

1. Select a transmitter channel to assign motor. Hold UP and DOWN buttons

2. Check motor direction. To reverse motor direction, hold MY/STOP button for

STOP

DOWN

3. Move motor to upper limit position. Hold MY/STOP and DOWN buttons until

LED Lights

Channel

Selector

4. While motor is at lower limit, hold UP and MY/STOP buttons until motor moves

5. Next, hold MY/STOP button until motor jogs.

6. Put motor into USER MODE by briefly pressing small programming button on

Pen

7. If programming additional shades on the same channel, put this motor to sleep

Programming

8. To wake motor up after putting to sleep, hold button on motor head for 1

Button

BACK

Setting an Intermediate Stop -

Shade MUST BE in USER mode.

SHADE

1. Move shade to desired mid-point location

2. To test, press the MY/STOP button when

3. To delete an intermediate stop, go to the

Add a Channel -

Shade MUST BE in USER mode.

Pen

1. Select channel currently operating motor,

2. Select new channel to add to motor, then

Programming

Button

3. The motor should now work on both the

BACK

Delete a Channel -

Shade MUST BE in USER mode.

Pen

1. Select channel operating motor that you

2. Select channel to remove, then hold

Programming

Button

BACK

until motor jogs, then release.

5 seconds until motor jogs. Check direction again.

motor moves down, then release. Use UP and DOWN buttons to move shade

to correct

lower limit and press MY/STOP.

up,

then release. The shade should move to upper limit and stop.

the back of the transmitter. Motor will jog.

until all motors on the same channel are programmed. To put to sleep, hold

button on motor head for one jog, release. Then hold UP/STOP/DOWN all at

the same time and wait for shade to jog. Motor is now asleep.

second. Shade will jog to indicate it is now awake.

and hold MY/STOP button until motor

jogs.

motor is standing still. The shade will move

to that intermediate location.

intermediate stop and hold the MY/STOP

button until motor jogs.

then hold programming button until motor

jogs.

hold programming button until motor jogs.

old and new channels.

want to keep, then hold programming

button until motor jogs.

programming button until motor jogs.

Motor should now only work

on channel kept from Step 1.

Adjust Limits in User Mode

SHADE

1. Move motor to limit

upper

lower

2. Hold UP and DOWN buttons until motor

limit

3. Move motor to its new limit location and

Reset Motor

1. Hold button on remote and wait for

Pen

Programming

Button

BACK

page 6 of 8

SHADE

(upper or lower)

changed. Shade must move to previously

set limit and will stop automatically.

jogs.

hold MY/STOP button until motor jogs.

3 jogs. Motor is now reset.

to be