Draper Futureguard FlexShade Zip Installation Instructions Manual - Page 5
Browse online or download pdf Installation Instructions Manual for Indoor Furnishing Draper Futureguard FlexShade Zip. Draper Futureguard FlexShade Zip 7 pages.
Print Page
Futureguard® FlexShade Zip™
ATTACHING SIDE CHANNELS
6b Insert the plastic Side Channel Top Guide into the top of the Side
Channel (See Fig. 13).
7b Insert Side Channel Guide into Bottom of the Headbox End Cap
(See Fig. 14).
Insert
Side
Channel
Top
Guide
Figure 13
S i
d e
C h
a n
n e
l
8b Attach Side Channel to the mounting surface using appropriate
fasteners.
IMPORTANT: Side Channels MUST be installed parallel and square
with a tolerance of +/-
⁄
1
8
9b Slide one Fabric Retainer Strip over the Zipper on one side of the
Hembar and insert into the Side Channel (See Fig. 11 on page 4).
Installing Zip 127 Angled Headbox Supported by Side Channels
ATTACHING SIDE CHANNELS
Measure the width of the Headbox. Side Channels must be installed to
match the exact width of the Headbox and must be square and parallel.
1 Use 3mm Hex Wrench to remove screws from Side Channels and set
aside.
2 Remove Side Channel Covers.
PLEASE NOTE: DO NOT remove the Bottom Caps from Side
Channels.
3 For jamb mounting, also remove the Zip Fabric Retainer Strip and set
aside.
4 Pre-drill through Side Channels in at least three mounting points
(See Fig. 9 under Preparation on page 4).
5 Attach Side Channel to the mounting surface using appropriate
fasteners.
6 If jamb mounted, replace the previously removed Zipper Fabric
Retainer Strips, making sure the angled leg is toward the back and
the Zipper "funnel" is up (See Fig. 13 above).
7 Re-attach Side Channel Covers using the screws removed in Step 1.
PLEASE NOTE: Failure to use provided fasteners to re-attach Side
Channel Covers may result in product failure in high wind.
8 Wall Mount Brackets are not used when Headbox is supported on
Side Channels.
by Draper
TO MOUNTED HEADBOX — JAMB MOUNTED SIDE CHANNELS
Angled leg of FABRIC
RETAINER STRIP must
be oriented towards back
U P
Side Channel Cross Section
" (3mm).
SURFACE OR JAMB MOUNTING
End Cap
Side
Channel
Guide
Figure 14
PLEASE NOTE: Make sure Fabric Retainers go back into the Side
Channels with Fabric Guide at the top of Side Channels and angled
leg oriented toward the back (See Fig. 11 on page 4).
10b Repeat Steps 6b – 9b for the other Side Channel.
11b Re-attach Side Channel Covers using the screws removed in Step
1 under Preparation on page 4.
PLEASE NOTE: Failure to use provided fasteners to re-attach Side
Channel Covers may result in product failure in high wind.
HEADBOX
MOUNTING
STUD
S i
C h
d e
a n
n e
l
Figure 16
Figure
9 Remove screws from bottom of Headbox, remove Fascia and set
aside (See Fig. 15).
Place Headbox onto the Side Channels while simultaneously
inserting the Zipper on each side of the Hembar into the Zipper
Retainer Strips in each Side Channel (See Fig. 16).
page 5
End Cap
Side Channel
Side
Guide Properly
Channel
Engaged
in Headbox
Figure 15
REMOVE
FASCIA
HEADBOX
MOUNTING
ZIPPER
STUD
HEMBAR
FABRIC
S i
RETAINER
d e
C h
STRIP
a n
n e
l