Draper SKYLIGHT 2 FLEXSHADE Instructions Manual - Page 5

Browse online or download pdf Instructions Manual for Indoor Furnishing Draper SKYLIGHT 2 FLEXSHADE. Draper SKYLIGHT 2 FLEXSHADE 8 pages. Motor operated skylight shades for very large applications

Print Page

SKYLIGHT 2 FLEXSHADE

8. Wind the Draw Cable 1-2 turns around the Cable Spool

at each end of the roller assembly.

9. Insert the Draw Cable through the Cable Spool and

Cable Clamp at each end of the assembly

10. Pull slightly on the Draw Cable to ensure that the Cable

Clamp has secured the Draw Cable.

11. Tighten the Draw Cable by pulling it through one of the

Cable Clamps.

12. Ensure the Draw Cable is routed properly around the

pulleys inside the Hem Bar assembly, as well as around

the pulleys in the Mounting Brackets

13. Cut off the excess Draw Cable for each end of the Roller

Assembly. Insert the Tensioning Tool into the Spring

Cassette Cable Spool and tension the shade 10-20

turns

(Fig. 9)

14. Set the Motor limits so that the shade stops about ½"

away from the Mounting Brackets at both ends

(13 mm)

of shade travel

(see "Limit Setting" section)

Caution: Allowing the Hem Bar to run into the Brackets

may result in damage to the unit. Ensure that the pinch

points between the Bracket and Hem Bar are clear

during operation.

15. Cycle the unit and make sure the Hem Bar does not

contact the Draw Cable during operation. If it does, then

more tension is required in the Guide Cable. If required,

retract the Tensioner, loosen the Nut, pull more of the

Guide Cable through the Tensioner, re-tighten the Nut,

and extend the Tensioner. Repeat as needed until the

Hem Bar does not contact the Draw Cable.

16. After confirming that the Hem Bar does not contact

the Draw Cable and that the installation is complete,

shorten the Guide Cables

(Fig. 10)

Caution: Once the Guide Cables are shortened, they

may need to be replaced if more tension is needed.

C016.085

Cable Clamp

(Fig. 7)

Orientation

is CRITICAL.

Figure 7

(Fig. 8)

Figure 10

Left-Hand Cable Spool

Trim excess cable

exiting the spool.

Fabric Panel

Draw Cable Insertion:

1-2 wraps around spool

Figure 9

Right-Hand Cable Spool