Draper 57862 Instructions Manual - Page 9
Browse online or download pdf Instructions Manual for Sander Draper 57862. Draper 57862 12 pages. 110v - 230v
Print Page
Regular inspection and cleaning reduces the
necessity for maintenance operations and will
keep your tool in good working condition. The
tool bearings (and gears – Model BS75) are life-
long lubricated. However it is advised to check
the condition of the grease in the BS75 every 100
hours, if necessary replace the grease. The motor
must be correctly ventilated during tool
operation. For this reason avoid blocking the air
inlets with hands. After use disconnect the tool
from the power supply and clean carefully, use
compressed air through ventilation slots.
DISPOSAL
At the end of the machine's working life, or when
it can no longer be repaired, ensure that it is
disposed of according to the standard regulations
of the country in which it is being used, and that
the disposal operation is carried out by
specialized personnel following authorized
guidelines.
In all circumstances:
- Do not abandon in the environment;
- Do not dispose of together with solid urban
waste products;
- Contact the special recycling centres.
MAINTENANCE &
PART REPLACEMENT
WARNING
Disconnect the plug from the power supply socket
before replacing any parts.
BRUSHES
The brushes must be replaced after approx. 150-
200 working hours, or if they are less then 5-6mm
in length.
WARNING
For correct tool operation always change the
brushes in pairs, not separately. The use of
original Draper spare parts is recommended.
After having fitted new brushes allow the motor to
run for at least five minutes without load for the
brushes to bed.
IMPORTANT:
This operation should only be performed by an
authorized person.
REPLACING THE POWER SUPPLY CABLE
Check that the power supply cable is in good
condition, if not have it replaced by an authorized
person.
- 8 -