Drawmer 1978 Operator's Manual - Page 5

Browse online or download pdf Operator's Manual for Recording Equipment Drawmer 1978. Drawmer 1978 11 pages. Stereo tone shaping fet compressor

Print Page

1. Specification

The 1978 unit will be supplied with a power cable suitable for domestic power outlets in your country. For your own safety,

it is important that you use this cable to connect to the mains supply earth. The cable must not be tampered with or

modified.

The power supply socket has an integral fuse drawer containing the power fuse of the same value, to suit the mains

voltage for which the unit has been supplied. Removal of the drawer is only possible with the power cord removed. The

fuse should never blow under normal operation. If the fuse is suspected of having blown, then a fault will have occurred

and this fault condition should be inspected by a qualified service engineer. When replacing the fuse, always comply with

the Safety Instructions.

If the unit is to be used with a mains input operating voltage different to that for which the unit is supplied, the following

procedure must be carried out by a technically competent person, (see following diagrams)

1: Disconnect the unit from the mains.

2: Using a number 1 size pozidrive

screwdriver, remove the seven self

-tapping screws that retain the top cover. Tw

screws are f ound al ong each

side; two along the top edge at the rear;

and the upper central screw on the front

facia panel.

3: Slide the voltage change-over switch

(S11) until the correct (or nearest) mains

input voltage is visible on the switch

actuator.

(see fig.2)

For con versi on t o 115Volt AC

(previously set to 230Volt AC).....

4a: Exchange the 160mA fuse below

the mains socket for a similar type rated

at 315mA

For conversi on to 230Volt AC

(previously set to 115Volt AC).....

4b: Exchange the 315mA fuse below

the mains socket for a similar type rated

at 160mA

In all cases:

5: Replace the top cover using the seven

screws.

6: Re-connect to mains power source.

POWER CONNECTION

Voltage Selector

Switch located here

DRAWMER 1978 O

PERATOR'S

fig.2 The Voltage Selector Switch

fig.3 The Location of the Fuse

ANUA

Fuse