Bosch 800 Series Installation Manual - Page 11

Print Page

Burner Cap and Burner Base Placement

After electrical connection is complete, place each

▯

burner base on the corresponding location on the

cooktop. One of the three bars on the burner base

should line up with the notch and prevent the base

from rotating. The small hole or cutout near the edge

should also line up with the igniter. Pay special

attention to avoid damaging the igniter during

installation of the base. See Illustration below.

Once each base is located and resting evenly, place

▯

each burner cap on its correct burner base. See

Illustration.

Place burner cap gently on top of base so that the

▯

prongs of the burner base fit snugly into the groove of

the burner cap.

If the maintop is removed by a certified installer (for

▯

example to check electrical or piping connection) the

panhead screws that were removed must be re-

installed to ensure proper functionality of burners.

Placing Burner Caps and Bases

Checking Burner Cap Placement

Check to make sure that there is no gap between the

▯

burner cap and burner base. See illustration below for

correct and incorrect placements of the burner cap.

You may gently try to move the burner cap from side

▯

to side to check if it is properly placed. If properly

placed, the cap will click from side to side as the

prongs hit the groove ridge.

Checking Burner Cap Placement