Bosch 800 Series Quick Start And Safety Manual - Page 6

Print Page

Bosch 800 Series Quick Start And Safety Manual

5 Settings

5.1 Available Settings

Below are some commonly used settings. To see all the set-

tings refer to the full online manual or go to

Dishwasher » Settings in the Home Connect app.

Setting

r-Rinse Aid

r:00 - r:06

d-Intensive drying

d:00 - d:01

b-End of cycle tone

b:00 - b:03

rE-Factory reset

6 Frequently Asked Questions

Why is food remaining on dishes after I run the cycle?

•

It is possible the dishes do not have adequate clearance between them for the water to reach effectively. Also, be sure nothing

is blocking the spray arms and that the filter is clean. Select the Heavy cleaning cycle.

Q: Why does the cycle run a long time?

•

Sensors in the dishwasher automatically increase the cycle time to ensure a good wash when heavy soil is detected.

•

Incoming water may not be hot enough and dishwasher has to heat it.

Why is E:XX (X can be any number) displayed?

•

This is an error code. For example E:22 indicates there is water in the sump because the filter is blocked or needs clean-

ing. See the Use and Care Manual for a list of error codes or at this link:

https://www.bosch-home.com/us/owner-support/get-support/general-error-codes

Factory

Description

setting

r:05

Setting to adjust the

amount of rinse aid

used in each cycle.

d:00/ off

Setting to increase

drying ability for

glasses or plastic.

Increases cycle length

and temperature.

b:02

Setting for the volume

of the tone at the end

of the cycle.

Restores the factory

settings on the dish-

washer.

5.2 Adjusting the settings

1. Press the power button.

2. Hold down button A sec to access the settings menu.

3. Press button A repeatedly to select the desired setting.

4. Press Start to change the value of the setting.

5. Press button A to save the setting.

Tip: The simplest way to change the settings is with the

Home Connect

app.