Bosch Benchmark 500 Series Installation Manual - Page 16
Browse online or download pdf Installation Manual for Oven Bosch Benchmark 500 Series. Bosch Benchmark 500 Series 39 pages. Built-in combination ovens
Also for Bosch Benchmark 500 Series: Installation Manual (22 pages)
Print Page
Three-wire Connection
power supply
junction box
red wires
white, bare, or
green wire
white wire
green wire
•
Connect red wire from oven to red wire in junction box.
•
Connect black wire from oven to black wire in junction
box.
•
Connect both green ground wire and white wire from
oven to white, green or bare neutral wire in junction
box.
The conduit cable, where connected at the oven, swivels.
Rotate conduit cable upward (or downward) and direct
through hole prepared in cabinet to attach to the junction
box.
To maintain serviceability, the flex conduit must not be
shortened and should be routed to permit temporary
removal of the oven.
9001080875 Rev A
Installing the Combination
Oven into the Wall Cabinet
NOTICE
black wires
Before installing the combination oven, be sure to
verify the cabinet dimensions and electrical
UL listed
connections.
connector
Check that the cabinet opening is level and plumb
for correct installation.
cable from
oven
Remove Lower Oven Door Prior to
Installation
It is recommended to remove the traditional (lower) oven
door to help reduce the unit weight and provide easier
access to the handholds located inside the oven. Do not
remove speed microwave or steam convection oven doors.
WARNING
9
•
•
•
•
•
The oven door is heavy and fragile. Use both
hands to remove the oven door. The door front
is glass. Handle carefully to avoid breaking.
Grasp only the sides of the oven door. Do not
grasp the handle as it may swing in your hand
and cause damage or injury.
Failure to grasp the oven door firmly and
properly could result in personal injury or
product damage.
To avoid injury from hinge bracket snapping
closed, be sure that both levers are securely in
place before removing the door. Also, do not
force door open or closed - the hinge could be
damaged and injury could result.
Do not lay removed door on sharp or pointed
objects as this could break the glass. Lay on a
flat, smooth surface, positioned so that the
door cannot fall over.
1. Be sure to read all
warnings and cautions
in the installation
manual regarding the
door removal before
attempting to remove
the door.
2. Open the door
completely.
3. Flip latch levers on
hinges all the way
down toward you.
English 11