Bosch Benchmark HBLP651LUC Service Manual - Page 27
Browse online or download pdf Service Manual for Oven Bosch Benchmark HBLP651LUC. Bosch Benchmark HBLP651LUC 45 pages. Built-in wall ovens
Also for Bosch Benchmark HBLP651LUC: Specifications (3 pages), Installation Manual (39 pages), Installation Manual (22 pages)
Print Page
58300000181895 ARA EN A
1. Remove the front panel as described in Replacing the Front Panel
Service Assembly section.
2. Using pliers, gently straighten each metal tab so that they align
with the slots in the display board, then lift the board off the tabs.
3. Position the new display board so that the slots in the board align
with the four metal tabs, and firmly push the board downward until
it is securely in place.
4. Slightly re-twist each of the four metal tabs.
5. Reassemble the control panel.
6. Reattach the control panel to the side trim and vent trim.
7. Restore power and test operation.
6.6
Cavity Lights
Each oven cavity utilizes two 120V/25W/G9 base halogen lights.
Replacement bulbs may be purchased locally.
Figure 39 Halogen bulbs (120V / 25W / G9 base
On double ovens, lights are either on or off in both cavities; it is not
possible to operate cavity lights independently.
The cavity light(s) can be turned on in two ways: by pressing Oven
Light or opening the oven door. If Oven Light had not been pressed to
turn light(s) on prior to opening the oven door, the light(s) will turn off
when the door is closed. If Oven Light had been pressed to turn
light(s) on prior to opening the oven door, the light(s) will remain on
after the door is closed.
In other words, the Oven Light switch overrides the door.
Copyright by BSH Home Appliances Corporation
This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.
JUNE 2014
6.6.1
Each rectangular glass light lens is secured to the lamp receptacle
assembly by two metal clips, which must be opened in order to
remove the glass lens and access the halogen bulb.
CAUTION
Turn off power to the oven at the fuse or breaker box–light socket
Be sure oven and lights are cool to the touch.
Handle glass lenses and glass bulbs carefully.
1. Turn off power to the oven at the main power supply (fuse box or
breaker box).
2. Remove oven racks to provide access to the light lens and
halogen bulb.
3. Optional: on ovens with bottom-hinge doors, the door may be
removed to provide easier access and visibility.
4. Insert the tip of a narrow flat blade screwdriver between one of the
metal clips and the lens at about a 40° angle. Gently pry the clip
upward to open.
Figure 40 Pry the lens clips open using a narrow flat blade screwdriver
1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614
Service Manual for Bosch Benchmark Series Built-in Wall Ovens
Replacing the Bulb
is live with door open.
Page 27 of 45
800 944-2904