Bosch Benchmark Series Service Manual - Page 27

Browse online or download pdf Service Manual for Oven Bosch Benchmark Series. Bosch Benchmark Series 36 pages. Built-in wall ovens
Also for Bosch Benchmark Series: Installation Manual (32 pages), Quick Reference Manual (4 pages), Service Manual (45 pages), Installation Instructions Manual (40 pages), Quick Start And Safety Manual (13 pages)

Print Page
Bosch Benchmark Series Service Manual
58300000187895 ARA EN A
9

SERVICE AND REPAIR: WARMING DRAWER

WARNING
!
To avoid possible electric shock, be sure electrical supply to the
range is turned off before servicing.
If testing the appliance requires the use of electrical power, exercise
extreme caution.
The warming drawer has push-to-open slides. To open the drawer,
press firmly on the center of the front panel, and the drawer should
spring open.
9.1

Removing the Drawer Assembly from Housing

1. Fully open the warming drawer and disengage the slides from
the rails by pushing upward on the left drawer latch clip and
downward on the right drawer latch clip.
Figure 31 Removing the drawer from the housing.
Copyright by BSH Home Appliances Corporation
This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.
MAY 2015
2. Grasp the drawer on both sides and firmly pull straight out
from housing.
3. Push the extended slides into the housing while the drawer is
removed.
9.2
1. Confirm that the slides are pushed into the cavity as far as
they will go.
2. Align the rails (riveted to the drawer assembly) with the slides
that are attached to the cavity walls.
3. Firmly push the drawer straight into the housing until the rails
engage and click into place.
4. Test the operation of the drawer by pushing in the center of
drawer front; open and close the drawer several times to
confirm that it is aligned and functioning correctly.
9.3
1. Disconnect power to the range.
2. Slide unit out of the cutout to gain access to the rear wall of
3. Remove the three screws securing the warming drawer wire
Figure 32 WD wire cover on rear of range
1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614
Service Manual for Bosch Benchmark Series Induction Slide-in Ranges

Replacing the Drawer Assembly in Housing

Replacing the Element

the cavity.
cover.
Page 27 of 36
800 944-2904