Bosch CBG855N 0 Series User Manual And Installation Instructions - Page 24

Browse online or download pdf User Manual And Installation Instructions for Oven Bosch CBG855N 0 Series. Bosch CBG855N 0 Series 36 pages.

Print Page
en Troubleshooting
Fault
The appliance is not
working.
"Sprache Deutsch"
appears in the dis-
play.
The operation does
not start or is inter-
rupted.
Appliance does not
heat up.
The time is not dis-
played when the ap-
pliance is switched
off.
The control ring has
fallen out of the
mount in the control
panel.
The control ring is dif-
ficult to turn.
The interior lighting
does not work.
Maximum operating
time reached.
A message with "D"
or "E" appears in the
display, e.g. D0111
or E0111.
24
Cause and troubleshooting
There has been a power cut.
Check whether the lighting in your kitchen or other appliances are working.
▶
There has been a power cut.
Implement the settings for the initial configuration.
▶
– Language
– Clock
Different causes are possible.
Check any notifications that appear in the display.
▶
→ "Displaying information", Page 12
Malfunction
Call the after-sales service.
▶
→ "Customer Service", Page 26
Demo mode is activated in the basic settings;
Briefly disconnect the appliance from the power supply by switching the circuit breaker in
1.
the fuse box off and back on again.
2.
Deactivate demo mode within three minutes in the
→ "Basic settings", Page 16.
There has been a power cut.
Open and close the appliance door once after a power failure.
▶
a The appliance is checked and is ready to use.
Basic setting has been changed.
Change the basic setting for the time display.
▶
→ "Basic settings", Page 16
The control ring has been detached.
1.
Insert the control ring into the mount in the control panel.
Push the control ring into the mount so that it clicks into place and can be turned.
2.
There is dirt below the control ring.
The control ring can be removed.
Note: To ensure that the mount remains stable, do not remove the control ring too often.
To loosen the control ring, press on the outer edge of the control ring.
1.
a The control ring tilts and is easier to grip.
Remove the control ring from the mount.
2.
Clean the control ring and its mount on the appliance carefully using soapy water and a
3.
dish cloth. Dry with a soft cloth.
Do not use any harsh or abrasive cleaning agents.
Do not soak the control ring.
Do not clean the control ring in the dishwasher.
The halogen lamp is defective.
Change the oven light bulb.
▶
→ "Replacing the oven light bulb", Page 25
To prevent an unwanted permanent operation, the appliance automatically stops heating
after several hours if the settings are unchanged. A message appears in the display.
The point at which the maximum operating time is reached is determined by the corres-
ponding settings for an operating mode.
To continue the operation, press any touch field and turn the control ring.
1.
If you do not need to use the appliance, use
2.
Tip: To prevent the appliance from switching off when you do not want it to, set a cooking
time.
→ "Setting the cooking time", Page 13
The electronics have detected a fault.
Switch the appliance off and on again.
1.
a If the fault was a one-off, the message disappears.
If the message appears again, call the after-sales service. Please specify the exact error
2.
message when calling.
→ "Customer Service", Page 26
​ ⁠ appears in the display.
​ ⁠ to switch it off.