Electrolux Oven User Manual - Page 18

Browse online or download pdf User Manual for Oven Electrolux Oven. Electrolux Oven 19 pages. Electrolux oven user manual

Print Page

ELECTRICAL CONNECTION

Prior to making the electric al connection, make sure

that:

The protection fuse and the domestic wire system

are suitable to carry the total electric load of the

oven (see rating plate).

Your domestic wiring system has an efficient earth

connection in compliance with the rules and laws in

force.

The wall socket or the omnipole switch used for the

electrical connection can easily be reached after the

oven is built in.

The appliance is delivered without an electric supply

cable, therefore, you will have to fit to it a supply cable

with standard plug, suitable for the total electric load

shown on the rating plate.

The plug is to be inserted into a suitable wall socket.

If you require a direct connection to the electric network

(mains), it will be necessary to fit between the

appliance and the mains an omnipole switch, aith a

minimum gap between contacts of 3 mm. suitable for

the required load and in compliance with rules in force.

The green 1 yellow ground wire must not be interrupted

by the switch.

The supply cable must in all cases be laid out in such

a way as to ensure that it does not reach at any given

point a temperature 50 C higher than the ambient tem-

perature.

The manufacturer disclaims any liability in case these

accident-preventing rules are not observed.

Suitable power supply cables are the following types,

considering the respective necessary section of cable.

•

H07 RN-F

•

H05 RN-F

•

H05 RR-F

•

H05 VV-F

CONNECTING THE TERMINAL BOARD

The appliance incorporates an easily accessible 6-

pole terminal board whose jumpers (bridges) are

already pre-set for operation on 230 V single-phase

(Fig. 19). In case where different mains voltage is

present, the jumpers on the terminal board must be

arranged as shown in the diagram (Fig. 20).

The ground cable must be connected to terminal

After connecting the supply cable to the terminal board,

secure it with a junction clamp.

FO 0330

1 2 3 4 5

230V 3~

1 2 3 4 5

230V 1~

1 2 3 4 5

400V 2N~

L1 L2

1 2 3 4 5

400V 3N~

L1 L2 L3 N

FO 0584-EN

Fig. 19

Section

of cable

(min.)

4 x 1.5 mm

L3 PE

Section

of cable

(min.)

3 x 2.5 mm

Section

of cable

(min.)

4 x 2.5 mm

Section

of cable

(min.)

5 x 1.5 mm

Fig. 20