Alemlube G10042 Owner Technical Manual - Page 4

Browse online or download pdf Owner Technical Manual for Tools Alemlube G10042. Alemlube G10042 6 pages. 14.4v cordless grease gun

Print Page

OWNER'S TECHNICAL MANUAL

TO FILL THE GUN WITH A FILLER PUMP

A bulk filler fitting will need to be installed in the Grease Gun Head Cap (not included). Replace the pipe plug in the head cap

with the bulk loader fitting. Engage the follower rod with the follower by rotating the follower handle. Insert the gun filler nipple

into the filler pump socket. Operate the filler pump to fill the container. When the follower rod groove is exposed, the grease tube

assembly is filled. The follower rod will be extended approximately 8 inches (20 cm). Disengage the follower rod from the follower

by rotating the follower handle. Push the follower rod into the grease tube assembly.

TO EXPEL AIR POCKETS

1. Free the follower rod from the grease tube assembly cap and depress the vent valve when pushing the follower rod forward.

2. Squeeze the switch several times to operate gun until trapped air is expelled.

Push the follower rod into the grease tube assembly.

INSPECTION, MAINTENANCE, AND CLEANING

1. WARNING: Make sure the Switch is in the "off" position, Battery is removed from the Grease Gun and unplug the Charger

from its electrical outlet before performing any inspection, maintenance, or cleaning.

2. BEFORE EACH USE: Check the general condition of the Grease Gun. Check for misalignment or binding of moving parts,

cracked or broken parts, leaking Battery Pack, damaged Hose, and any other condition that may affect its safe operation.

If abnormal noise or vibration occurs, have the problem corrected before further use.

DO NOT USE DAMAGED EQUIPMENT

1. BATTERY PACK PRECAUTIONS: Never burn Batteries, as they can explode in a fire. Do not charge leaking Batteries.

Only a qualified service technician should perform maintenance on the Battery Pack. Contact local solid waste authorities

for instructions on correct disposal or recycling of the Battery Pack.

2. DAILY: Use a soft, dry cloth, remove all dirt, grease, and debris from the exterior of the Grease Gun.

Do not use solvents to clean the Grease Gun.

3. WHEN STORING: Always remove the Battery Pack from the Grease Gun. Keep the Grease Gun and its accessories in a clean,

dry location and out of children reach.

Problem

Motor does not run

Pressure relief valve remains open

Gun does not dispense grease

Continuous loss of prime

NSW/ACT

QLD/PNG

TEL: (02) 9677 1555

TEL: (07) 3204 9166

FAX: (02) 9675 1155

FAX: (07) 3204 1224

14.4V Cordless Grease Gun

Possible Cause

Battery discharged

Faulty wiring

Blockage in line or fitting

Grease tube is empty

Loss prime

Air pockets

Follower is binding in grease

VIC/TAS

TEL: (03) 8787 8288

FAX: (03) 8787 8266

Visit our website at

www.alemlube.com.au

Corrective Action

Recharge battery

Take to service center

Check hose and grease fitting

Remove and clean

Check grease tube contains grease

Prime the gun

Empty grease tube assembly, refill, and re-prime

Replace grease tube assembly

SA/NT

TEL: (08) 9302 4199

TEL: (08) 8241 7111

FAX: (08) 9303 2095

FAX: (08) 8241 7011

www.alemlube.co.nz

G10042

TEL: (09) 447 1007

FAX: (09) 447 1008