Bosch HB 43R Series Instruction Manual - Page 14
Browse online or download pdf Instruction Manual for Oven Bosch HB 43R Series. Bosch HB 43R Series 24 pages.
Print Page
Installing
Follow steps 2 to 4 with doors that have two glass panels.
When installing, ensure that the "right above" inscription on the
lower left part is inverted.
Insert the glass panel by tilting it backwards (Figure A).
1.
Insert the upper glass panel on both mounts by tilting it
2.
backwards. Ensure that its smooth surface is facing
outwards. (Figure B)
Troubleshooting
Quite often, when there is a malfunction, it is usually a small
irregularity which is easy to rectify. Before contacting the
Technical Assistance Service, try to determine the cause of the
fault using the following table.
Troubleshooting table
Fault
Possible cause Solution/advice
The oven does
The fuse has
not work.
blown.
Power cut.
The display
Power cut.
panel shows a
flashing
sym-
0
bol and four
zeros.
The oven does
There is dust on
not heat up.
the contacts.
Error messages
When the display panel shows an error message with
the
button. The message will disappear. The set time
0
function will be deleted. If the error message does not
disappear, call the Technical Assistance Service.
The following error messages can be solved by the user.
Error message Possible cause Solution/advice
A button has
"‹‚‚
been pressed
for too long or
has got stuck.
:
Risk of electric shock.!
Incorrect repairs can be dangerous. Repairs may only be
carried out by qualified personnel from the Technical
Assistance Service.
14
Check the state of the fuse
in the fuse box.
Check that the light in the
kitchen and other house-
hold appliances are work-
ing.
Set the time once again.
Turn the control knobs sev-
eral times in both direc-
tions.
, press
"
Press all of the buttons one
by one. Check if any button
is stuck, covered or dirty.
Fit and tighten the cover.
3.
Refit the oven door.
4.
Once the glass panels have been correctly fitted, the oven is
ready to use.
Changing the oven bulb
If the oven light bulb is damaged it must be replaced. Special
25 W, E14, 220 V-240 V heat-resistant light bulbs (to 300 ºC
temperature) can be obtained from the Technical Support
Service or in specialist shops. Only use this type of bulb.
:
Risk of electrical discharge and the resulting shock.!
Disconnect the appliance from the mains. Ensure that this is
turned off.
Place a dishcloth into the cold oven to avoid damage.
1.
Remove the glass protection by unscrewing it to the left.
2.
Replace the bulb with a similar bulb.
3.
Screw the protection glass back into place.
4.
Remove the dishcloth and switch the oven back on at the
5.
mains.
Protective glass panels
Damaged protective glass panels must be replaced. Protective
glass panels cay be obtained from the Technical Assistance
Service. Please quote your appliance's product number and
production number.