Electrolux 300 Series Use & Care Manual - Page 20

Browse online or download pdf Use & Care Manual for Washer Electrolux 300 Series. Electrolux 300 Series 39 pages. Front load dryer
Also for Electrolux 300 Series: Owner's Manual (11 pages), Installation Instructions Manual (50 pages), Use & Care Manual (28 pages), Use & Care Manual (46 pages)

Print Page

20 Controls and Settings

IMPORTANT

• If steam is selected, rinse tempera-

tures will be elevated.

• If the wash cycle is paused or can-

celled during a steam cycle, the door

will remain locked until it cools. You

may manually perform a rinse & spin

cycle to cool the internal temperature

sooner.

• During a steam cycle, steam exiting

from the rear vent of the washer is

normal and not cause for alarm.

Wash Cycle Options

extra rinse

Use this option when additional rinsing is

desired to remove excess dirt and detergent.

It is recommended for heavily soiled loads or

if household members have sensitive skin.

wrinkle release (on select models)

After the final spin, the washer will perform

a "dry" agitation to loosen the garments

from the side of the drum.

extended refresh (on select models)

Select extended refresh if you will be

unable to remove the load right after the

cycle is complete. The washer recognizes

the load has sat too long and will do a

rinse and spin to keep the load fresh for

up to 12 hours. When you are ready to

remove the load during the extended

refresh segment, you must press cancel

to end the cycle and open the door.

PODS

(on select models)

Select this option when using a detergent

pack in a model equipped with a PODS

button (on select dispenser only). This

option will divert the flow of water to the

detergent pack compartment optimizing

the detergent pack performance.

Control Options

control lock

To lock the controls between cycles,

scroll to the control lock option and

press select. The control lock icon

will show on the LED display. To unlock the

controls scroll to the control lock option again

and press select. Use this feature to reduce

the likelihood of accidental operation by chil-

dren. Washer cycles will not run when

Control Lock is activated.

PODS

is a registered trademark of Procter & Gamble Company, Cincinnati OH, used under license by Electrolux.

delay time

Use delay time to delay the

start of the washing cycle from

30 minutes to 12 hours. After

selecting the delay time option,

press select button to scroll to the desired

delay time. The delay time icon will il-

luminate on the LED display to indicate the

delay time option is activated, The time

will begin counting down on the LED display

once the washer start/pause button has

been pressed.

Chime

A signal will sound at the end of each

cycle (and periodically during extended

refresh) if option is activated.

To mute or unmute the chime, press and

hold the select button for 3 sec. This will

not affect any of the other button tones.

options

hold 'select' 3 s to mute/unmute

Other Features

LED display

Icons may vary according to model.

The estimated total cycle time will be dis-

played when the cycle is selected. The time

may increase if water pressure is low, over-

sudsing occurs or the load becomes unbal-

anced. The approximate time remaining will

be displayed during the cycle. As the washer

progresses through the cycle phases, the

row of cycle phase indicators lights up under

the cycle time. The eco, control lock, close

door, mute (some models) and delay time

will also appear on this LED display.

select

de-select