Electrolux 400 SERIES Installation Instructions Manual - Page 13
Browse online or download pdf Installation Instructions Manual for Washer Electrolux 400 SERIES. Electrolux 400 SERIES 50 pages. Front load dryer
Also for Electrolux 400 SERIES: Use & Care Manual (16 pages), Use & Care Manual (39 pages), Use & Care Manual (28 pages), Use & Care Manual (46 pages)
Print Page
Removing Door Assembly, continued
6. Release wiring harness from retainer
on plastic terminal cap. Then release
terminal from terminal cap. Save the
cap to reinstall later.
Removing Door Lock and Plas-
tic Hole Cover
1. Locate and remove both screws from
door lock. Save screws for later.
2. Rotate the lock as you pull it out
through the front panel. Take care not
to pull too hard or too far as the lock is
still attached to the wiring harness.
x2
Coarse
Thread
3. Disconnect the wiring harness terminal
from the door lock. Set the door lock
aside for reinstallation later.
4. Pry the bottom of the plastic hole cover
upward to release it from the front
panel. You may have to use a non-
scratching plastic knife if you are un-
able to release it manually. Then, slide
the cover down slightly and remove it
from the front panel.
Front
Panel
2
1
Reversing Door
Reinstalling Door Lock and Hole
Cover
1. Move the plastic cover to the other side
of the front panel. Position the cover so
the "hook" is at the bottom. Insert hook
into lower slot, slide the cover down,
and press upper retention tabs into
opening until they snap into place.
2
1
2. Insert wiring harness into door lock.
3. Insert door lock into front panel and
reinstall door lock screws.
Coarse
Thread
Reversing Door Assembly
1. Locate nine screws on inner door ring.
Remove each and save for reinstal-
lation later. Remove inner door (with
hinge) and carefully set aside.
2. Lift door glass slightly and rotate 180
degrees, setting it back onto outer door.
180
13
1
1
2
2