Electrolux 506063 Manual - Page 11

Browse online or download pdf Manual for Washer Electrolux 506063. Electrolux 506063 28 pages.

Print Page

IMPORTANT!

Appliance installation operations must

only be carried out by specialized Techni-

cians provided with all the appropriate

personal protection equipment (safety

shoes, gloves, glasses, overalls, etc.),

tools, utensils and ancillary means.

Customer responsibilities

The Customer must provide for the following:

Install a disconnecting switch with a capacity at

least equal to that given in the technical data table,

a 30mA residual current circuit breaker and an

overcurrent device (magnetothermal cut-out with

manual reset or fuse) between the appliance and

the mains power outlet. The chosen device must be

lockable in the open position in case of mainte-

nance.

install an adequate electrical power supply ahead

of the appliance, according to the equipment's tech-

nical specifications (Table 1 and D2 "Characteris-

tics of power supply");

the equipotential connection of the workplace elec-

trical system to the metal structure of the appliance

by means of a copper cable of adequate section

(see position "EQ" in par. F6.2 "Installation dia-

grams");

Adducting for the electrical connection between the

workplace electric panel and the equipment;

the water supply and drain connections and other

connections as indicated in Table 1 and par. F6

"Plumbing connections";

Characteristics of the place of appliance

installation

The appliance is designed for installation in profes-

sional and not domestic-type kitchens. Water collec-

tion traps/metal grates must be arranged in the floor at

the appliance discharges (see pargraph F6.2 "Installa-

tion diagrams"), possibly replaceable with a single

water trap sized for a flow rate of at least 3 l/s.

Appliance space limits

A suitable space must be left around the appliance (for

operations, maintenance, etc.).

The passages enabling personnel to operate on the

appliance must be at least 50 cm wide, except at the

rear of the appliance.

The size must be increased in case of use and/or

transfer of other equipment and/or means or if exit

routes are necessary inside the workplace.

Positioning

The appliance must be taken to the place of installa-

tion and the packing base removed only when being

installed.

INSTALLATION AND ASSEMBLY

Arranging the appliance:

•

Wear protective gloves and unpack the appliance

(Figure 5).

Figure 5 Unpacking

•

Lift equipment with a lift truck, inserting the forks as

indicated below, remove the base and position the

appliance where it is to be installed (Figure 6).

Figure 6 Appliance positioning

•

Remove the wooden spacers "A" on the appliance

base by undoing the four M8 screws (see Figure 7).

Electrolux 506063 Manual - Page 11

INSTALLATION AND ASSEMBLY

Figure 5 Unpacking

Figure 6 Appliance positioning

Figure 7 Removal of wooden spacers