Electrolux 506064 Manual - Page 24

Browse online or download pdf Manual for Washer Electrolux 506064. Electrolux 506064 28 pages.

Print Page

Correct use

Our appliances are designed and optimized in order to

obtain high performance and efficiency. This equip-

ment must only be used for its expressly designed pur-

pose, i.e. washing items with water and specific

detergents. Any other use is to be deemed improper.

Characteristics of personnel enabled to

operate on the appliance

Operator qualified for normal use must have at least:

•

knowledge of the technology and specific experi-

ence in operating the appliance;

•

adequate general basic education and technical

knowledge for reading and understanding the con-

tents of the manual,

•

the capacity for a correct interpretation of the draw-

ings, signs and pictograms;

•

sufficient technical knowledge for safely performing

his duties as specified in the manual;

•

knowledge of the regulations on work hygiene and

safety.

In the event of a significant anomaly (e.g. short circuits,

wires coming out of the terminal block, motor break-

downs, worn electrical cable sheathing, etc.) the oper-

ator qualified for normal appliance use must:

•

immediately deactivate the appliance by turning the

main switch to "O" ;

•

close the appliance water supply by shutting off the

water.

First use

Carry out a couple of cycles without items to flush out

any industrial grease which has remained in the tank

and piping.

Daily activation of appliance

•

Make sure the filters and the arms are correctly fit-

ted according to that indicated in par. H1.2 "Check

the positioning of tank components" and F8

"Energy control arrangement".

•

Open the water supply cocks.

•

Activate the main switch by turning it to position "I".

•

Open the door and check that all the components

are in their correct position.

•

Close the door.

•

Switch on the appliance by pressing the button "A".

The button "A" lights up (Table 2 "Control panel"), indi-

cating that the appliance is powered and that water is

being introduced and heated.

The word "FILL" is shown on the display during the

entire filling and heating stage:

NORMAL APPLIANCE USE

FIL

Warning, this appliance does the first tank filling

through several consecutive hot rinse cycles, while the

display shows the message FILL (flowing).

This system let save up to 30% of time than traditional

models.

If the door is opened during this stage the message

"CLOSE" will appear on the display:

CLO

The filling and heating stage has finished when the

display shows the tank temperature:

To display the boiler temperature during heating of the

tank, open the door and press the button "G" (Table 2

"Control panel").

Wash cycles

The wash cycle includes a wash with hot water and

detergent at a temperature of at least 55°C/ 131°F and

a rinse with hot water and rinse aid (min. 82°C / min.

180°F).

Table of times

Standard cycle time with supply water at 50 °C :

EPPW

3 min

A device lengthens the cycle time if the water in the

boiler has not reached the minimum temperature for

correct rinsing.

The cycle times and the temperature may be

personalised (e.g. increase of the rinse time and

temperature).

The cycle times should only be set by a specialised

technician.

Operation

The filling and heating stage has finished when the

display shows the tank temperature:

III

6 min

9 min

INFINITE