Electrolux EFLS210TIW Use & Care Manual - Page 11

Browse online or download pdf Use & Care Manual for Washer Electrolux EFLS210TIW. Electrolux EFLS210TIW 22 pages. Front load dryer
Also for Electrolux EFLS210TIW: Installation Instructions Manual (33 pages)

Print Page

WARNING

FIRE HAZARD

To avoid fire hazard, DO NOT dry items

containing feathers or down, foam rubber,

plastics similarly textured, rubber-like materials.

high

Recommended for durable fabrics and towels.

normal

Recommended for most cotton fabrics.

low

Recommended for delicate fabrics.

air dry

Uses only ambient air temperature without heat.

Dryness Level (Auto Dry)

To change the preset level, press the dryness

option button to scroll to the degree of

dryness desired.

To protect your fabrics, not all dryness levels

are available with every cycle. If a dryness level

is not appropriate for the cycle, it cannot be

selected.

• Select the normal dry level for most Auto

Dry cycles.

• Occasionally a load may seem too damp

or over-dried at the end of the cycle. To

increase drying time for similar loads in the

future, select high.

• For loads requiring less drying time, select less.

• Select damp for items you wish to partially

dry before hanging or ironing.

Adjusting the remaining moisture

level

Your condensation dryer comes from the

factory pre-set to dry your laundry at a

standard level. If you would like to increase

the dryness level of your laundry, you may

follow these steps to change the default

degree of remaining moisture:

Press the power button to turn on the

unit.

Turn the cycle selector to any dry pro-

gram.

Wait approximately 8 seconds.

Press and hold the extended tumble

and wrinkle release buttons simultane-

ously for 4 seconds.

Controls and Settings

One of the following indications will appear on

the display:

• 0- Standard dry level (factory default)

• 1- More dry level (this will increase the

time of each cycle by approx. 10%)

• 2- Max dry level (this will increase the

time of each cycle by approx. 20%)

Please note that this dryness level change will

apply to every dry cycle and cycle settings

combination except for the time dry cycle.

The time dry cycle dryness level and available

cycle times cannot be changed by adjusting

the remaining moisture level setting.

Press and hold the extended tumble

and wrinkle release buttons simultane-

ously again for 4 seconds to continue

scrolling through the dryness levels.

Repeat this step until the number of the

desired remaining moisture level appears

in the display.

Once the desired remaining moisture

number is shown in the display, wait 5

seconds. The display will then return

to the normal mode and the selected

remaining moisture level will be used for

each future cycle.

Cycle Options

To add options, press the corresponding option

button to illuminate the selection desired. To

delete options, press the option button again

and the indicator light will turn off. If attempting

to select an unavailable setting or option for

any given cycle, a beep will be heard and the

corresponding setting/option LED will not light.

To protect your fabrics, not all options are

available with every cycle. Not all options are

available on every model.

wrinkle release

Select wrinkle release if the dried load

might not be removed promptly at the end of

the cycle. This option provides an additional

30 minutes of short intermittent tumbling.

The drum will tumble a few seconds in each

direction, then rest for approximately 30

seconds before repeating. The load may be

removed at any time during wrinkle release. A

beep will be heard periodically throughout this

phase if the mute sound option is not selected.