Alemlube HR90050 Owner Technical Manual - Page 7

Browse online or download pdf Owner Technical Manual for Tools Alemlube HR90050. Alemlube HR90050 10 pages. Spring rewind hose reel

Print Page

Operational Instructions for HR90000 Series

Industrial Hose Reel 286X Series Instruction

Operation

1. Check reel for correct operation by slowly pulling out the hose. A "clicking" noise will be

heard every half revolution of the drum.

2. To latch the reel, pull out the hose and allow it to retract after hearing the first second or third

" click".

3. To unlatch, slowly pull out the hose until the "clicking" noise stops, then let the hose retract

until the hose stop rests against the hose guide. Note: To avoid damage to the reel, always

hold on to the hose while it is rewinding.

4. Periodically check the hose condition for wear or damage, and check the swivel fitting for

leakage. Replace any worn, damaged, or leaking parts.

Adjustment of Spring Tension

1. Pull out approximately 6ft or 2m of hose and allow the drum to latch.

2. Remove hose stopper from hose, and feed hose back through guide.

3. Wrap the pulled hose one time around the drum to increase tension or un-wrap hose one

time from drum to decrease tension.

4. Re-insert hose through guide, and install stopper onto hose end.

5. Unlatch the Drum and check tension. Pull hose from reel, and adjust stopper position if

necessary.

Replacement of Hose

1. Turn off supply to reel.

2. Pull out all the old hose and lock the reel in this position. Caution: Make sure reel drum is

securely locked and cannot rotate back.

3. Remove two hose clamps from hose.

4. Carefully disconnect hose from swivel joint on side of reel, or male fitting in axle center and

remove old hose.

5. Feed new hose through guide and opening in drum, and connect to swivel. Re-install two

hose clamps, on inside and outside of drum flange. Install stopper on other end of hose in the

same position as before.

6. Carefully release the drum latch, and slowly allow the hose to wind onto the reel. Note: Final

spring adjustment is accomplished by adding or removing wraps of hose around the drum.

(Details see spring tension adjustment).

Spring Canister Warning

If the rewind spring fails for any reason: For safety reasons, the manufacturer strongly

recommends the replacement of the spring canister be carried out by a professional mechanic.

Limited Warranty

1. The manufacturer warrantees this hose reel against defects in material and craftsmanship, for

a period of 12 months from date of purchase.

2. Hose, if supplied with reel, O-rings, plastic rollers and rubber stopper are deemed to be

normal wear items; not warranted.

3. Manufacturer's liability is limited to replacement or repair of defective material within the

warranty period, when returned freight prepaid to the distributor or their designated service

depot.

4. The warranty does not cover damage caused by accident, misuse or faulty installation.

5. The reel must be installed and maintained in compliance with the instructions.

NSW

QLD / PNG

TEL: (02) 9677 1555

TEL: (07) 3204 9166

FAX: (02) 9675 1155

FAX: (07) 3204 1224

Visit our website at

6 OF 9

VIC / TAS

TEL: (03) 8787 8288

TEL: (08) 9302 4199

FAX: (03) 8787 8266

FAX: (08) 9303 2095

www.alemlube.com.au

SA / NT

TEL: (08) 8241 7111

FAX: (08) 8241 7011

www.alemlube.co.nz

TEL: (64) 9 447 1007

FAX: (64) 9 447 1008