AirStage UTY-RSKY Installation Manual - Page 4
Browse online or download pdf Installation Manual for Remote Control AirStage UTY-RSKY. AirStage UTY-RSKY 9 pages. Simple remote controller
Also for AirStage UTY-RSKY: Operatiing Manual (2 pages), Operating Manual (2 pages)
Print Page
5.1. Installation
Insert the end of a fl at blade screwdriver at the
the rear case and remove the rear case top by turning the screwdriver.
Be careful to avoid breaking the cable by over-tightening the cable tie.
When connecting the remote controller cables, do not overtighten the
screws.
(1) Pass the remote controller cable through the hole in the rear case
and connect the remote controller cable to the remote controller
terminal block specifi ed in Fig. 1.
(2) Clamp the remote controller cable sheath with the binder as shown in
Fig. 1.
Fig. 1
3. COM (Black)
2. Signal (White)
1. 12V (Red)
Hole
Cable tie*
* Tighten the cable tie fi rmly so that pulling force does not propagate to the
terminal connection even if force of 30N is applied to the cable.
(3) Cut off the excess cable tie.
(4) Install the rear case to the wall, box, etc., with 2 screws (Fig. 2).
En-3
of the groove at the side of
CAUTION
7
7
7
Unit : mm
1. 12V (Red)
2. Signal (White)
3. COM (Black)
Tightening torque
0.8 to 1.2N • m
(8 to 12 kgf • cm)
Cable tie
Fig. 2
Remote Controller Cable
Box
Insert the upper case fi rmly. If improperly attached, it will cause the upper
case to fall off.
When installing remote control cables,
cover the remote control cables using an
isolation tube or cover at least 1mm thick
minimum to prevent direct contact with
the cables.
Perform functional earthing the remote controller if it
has a functional earthing cable. (UTY-RSKYT)
Insulation*
Remote controller
* Wrap the connector and remote controller cables with vinyl tape
or some other type of insulation as shown in the fi gure.
5.2. Setting the DIP switch
Set the remote controller DIP switches. (Fig. 1)
Fig. 1
ON
OFF
Switch state
NO.
OFF
2
★ Master
DIP switch
1,3 to 6 ★ Fixed at OFF
Rear Case
Screws
CAUTION
Cable cover
Epoxy putty
Remote controller
cable
Shield
Connection
Functional earthing
cable (from main unit)
DIP switch
Detail
ON
Refer to 6. INSTALLA-
Slave
TION METHODS.
Cannot be used
(★ Factory setting)