Alemlube HR90090 Owner Technical Manual - Page 3

Browse online or download pdf Owner Technical Manual for Tools Alemlube HR90090. Alemlube HR90090 6 pages. Dual pedestal spring rewind hose reels

Print Page

OWNER'S TECHNICAL MANUAL

OPERATION

1. Pull out the hose slowly to the desired length and release it. The hose may be retracted by a small section

(about 10-15m) and placed into a locked status for use.

2. To retract the hose, pull the hose out about 4cm (1.6in) and release it. The hose can be retracted to the hose reel.

3. There is a slow retraction device installed on the hose reel. When the hose is in the retraction state, the slow

retraction device will have a deceleration effect, which can significantly reduce the retraction speed of the hose

(the longer the length of the retracted hose, the more obvious the deceleration effect), and ensure the operation

safety of the hose when it is retracted.

4. Periodically check the hose condition for wear or damage, and check the swivel fitting for leakage.

Replace any worn, damaged, or leaking parts.

Hose Replacement

1. Turn off air supply to reel and carefully release pressure in hose.

2. Securely stabilize the reel by mounting or clamping to work surface.

3. Pull out all the old hose and lock the reel in this position.

Caution: Make sure reel drum is securely locked by letting ratchet teeth engage.

4. Remove the two hose clamps connecting the hose to the reel.

5. Carefully disconnect hose from the swivel joint on the side of the reel and discard old hose.

6. Feed new hose through guide and opening in drum, use sealant and connect to swivel.

Reuse hose clamps on inside and outside of drum flange to reconnect hose.

7. Securely install stopper on other end of the hose in the same position as before. Adjustments can be made later.

WARNING: Notice direction of the red arrow label on.

8. Carefully release the drum latch and while securely holding the hose, slowly allow the hose to wind onto the reel.

NOTE: Final spring adjustment is accomplished by adding or removing wraps of hose around the drum.

(Refer to Spring Tension Adjustment).

WARNING: The rewind spring is not serviceable. Do not remove spring cover.

SPRING CANISTER WARNING

If the rewind spring fails for any reason:

For safety reasons, Alemlube strongly recommends the replacement of the spring canister be carried out

by a professional mechanic.

NSW/ACT

QLD/PNG

TEL: (02) 9677 1555

TEL: (07) 3204 9166

FAX: (02) 9675 1155

FAX: (07) 3204 1224

Dual Pedestal Spring Rewind Hose Reels

VIC/TAS

TEL: (03) 8787 8288

FAX: (03) 8787 8266

Visit our website at

www.alemlube.com.au

SA/NT

TEL: (08) 9302 4199

TEL: (08) 8241 7111

FAX: (08) 9303 2095

FAX: (08) 8241 7011

www.alemlube.co.nz

HR90000

Series

TEL: (09) 447 1007

FAX: (09) 447 1008