Bdcom S2008 Hardware Installation Manual - Page 11

Browse online or download pdf Hardware Installation Manual for Network Router Bdcom S2008. Bdcom S2008 16 pages.

Print Page

Note:

S2008 switch Console Port does not support flow control. Therefore, "Data Flow Control" should be set

"No" while using super terminal to manage switch.

3.3.1

Console port connection

This cable is used to connect BDCOM S2008 switch console port to external terminal. One end is RJ45

8-pin plug. The other end are 25-hole (DB25) and 9 –hole (DB9) plugs. RJ45 connecter plugs into

BDCOM S2008 switch console port. Use DB25 and DB9 according to the terminal parallel port. The

side of the cable is shown as follows. The product No. of this cable is RLC0301.

BDCOM S2008switch provides 24 10/100Base-TX ports. Each port is embedded with 2 LEDs to

indicate the statues of Link/ACT and 10/100M. Use switchUTP to connect to other Ethernet terminals.

UTP no. and console no. are the same. Refer to the following chart..

All of the 24 10/100Base-TX ports of BDCOM S2008 switch support auto-MDIX. Choose the

connection which best fits the connection between BDCOM S2008switch and Ethernet terminal.

10/100Base-TX port and other Ethernet terminal connection is shown as follows:

Data set ready

Transmitted data

request to send

clear to send

Data terminal ready

signal ground

BDCOM S2008 Switch Hardware Installation Guide

DSR

No connect

TXD

Output

RTS

No connect

CTS

No connect

DTR

No connect

GND

- 9 -