Bosch HBG38U7 0 Series Instruction Manual - Page 20

Browse online or download pdf Instruction Manual for Oven Bosch HBG38U7 0 Series. Bosch HBG38U7 0 Series 40 pages.

Print Page

Troubleshooting

Malfunctions often have simple explanations. Refer to the table
before calling the after-sales service as you may be able to
remedy the fault yourself.

Malfunction table

If a dish does not turn out exactly as you wanted, refer to the
Tested for you in our cooking studio section, where you will
find plenty of cooking tips and tricks.
Problem
The appliance does not work.
The text "Time 00:00" appears in the dis-
play. The time is not the current time.
The oven does not heat up or the type of
heating selected cannot be set.
The oven does not heat up. The text
"Demo" is displayed.
A reference to the cleaning system
appears when the
p
button is pressed.
"Automatic switch-off" appears in the dis-
play.
Error messages with E
If an error message with E is shown in the display, press the
button. This cancels the error message. You may then have
0
Error message
E011

Replacing the bulb in the oven ceiling light

If the bulb in the oven light fails, it must be replaced. Heat-
resistant, 25 watt, 230 V halogen bulbs are available from the
after-sales service or specialist retailers. When handling the
halogen bulb, use a dry cloth. This will increase the service life
of the bulb. Only use these bulbs.
:
Risk of electric shock!
Switch off the circuit breaker in the fuse box.
Place a tea towel in the oven when it is cold to prevent
1.
damage.
Turn the glass cover anti-clockwise to remove it (Fig. A).
2.
Pull out the bulb (do not turn it ) (Fig. B). Insert the new bulb,
3.
making sure that the pins are in the correct position. Push the
bulb in firmly.
20
:
Incorrect repairs are dangerous. Repairs may only be carried
out by one of our trained after-sales engineers.
Possible cause
Faulty circuit breaker
Power cut
Type of heating not recognised
The oven is in demo mode.
The appliance is not equipped
with the cleaning system.
Automatic switch-off has been
activated. The oven switches off.
to reset the time. If the error is shown again, call the after-sales
service.
You can take remedial action yourself if the following error
message is displayed.
Possible cause
A button has been pressed for too
long.
4.
5.
Risk of electric shock!
Note/remedy
Look in the fuse box and check that the circuit
breaker is in working order.
Set the current time and press the
Make the settings again.
Switch off the circuit breaker in the fuse box and
then switch back on after approx. 20 seconds. In
the next 2 minutes hold the
four seconds until the text "Demo" disappears.
The button only works if you retrofit the self-clean-
ing ceiling and the side components and subse-
quently activate the cleaning system in the basic
settings. See the Cleaning system section and the
Basic settings section.
Press any button. The text disappears. You can
make settings again.
Note/remedy
Press all buttons individually. Check that the but-
tons are clean. If the error message remains,
please contact the after-sales service.
Screw the glass cover back in.
Remove the tea towel and switch on the circuit breaker.
button.
0
button down for
D