AirStage UTY-DCGY Installation Manual - Page 7

Browse online or download pdf Installation Manual for Controller AirStage UTY-DCGY. AirStage UTY-DCGY 11 pages. Central remote controller
Also for AirStage UTY-DCGY: Installation Manual (9 pages)

Print Page
61 31

DIP Switch Setting

CAUTION
Use an insulated screwdriver to set the DIP switches.
Do not touch the DIP switch with your hands.
▪
Before using this product, always set DIP switch (SW1)-
No.1 to "ON".
If not set, when the main power is turned on again, the
set data by menu operation will be erased and cause
erroneous operation.
▪
Do not change the setting of other switches.
[DIP Switch(SW1)]
▪
Performs the enabling/disabling of the backup function
by the internal battery.
▪
It is disabled when shipped from the factory to prevent
consumption of the charge.
DIP Switch (SW1)
DIP Switch
No.
OFF
ON
1
 Disabled
Enabled
2
-
3
-
61 41

Installation Method - Integrated type

6. 4. 1
Integrated type
(1)
Pass power supply cable-A through Hole-A,
and connect it to the power supply terminal of
the power supply unit PC board.
(2)
Fix with the binder.
Power supply cable-A
Binder (accessory)
ON
OFF
1 2 3
Details
For enabling/disabling the
backup function.
Not used. Fixed to "OFF".
Not used. Fixed to "OFF".
(  :Factory setting)
Hole-A
POWER SUPPlY
L N
Power supply terminal
(3)
Open the knockouts (2 places), and install the
one touch bush (2 pcs, accessories).
(4)
Connect the connector of power supply cable-B
(accessory) to the relay connector of the cable
coming from the power supply unit PC board.
One touch bush (accessories)
knockout
Hole-B
power supply
cable -B
(accessory)
knockout
Hole-C
One touch bush
(accessories)
(5)
Pass power supply cable-B through Hole-C and
Hole-D, and connect it to rear panel terminal.
(6)
Pass transmission cable through Hole-B,
Hole-C, and Hole-D, and connect it to rear
panel terminal. Fix with the binder(accessory).
Transmission cable
Binder
(accessory)
Power supply
cable-B
Hole-C
Hole-D
(7)
Fix with the binder (accessory).
Binder
(accessory)
Power supply cable-B
Transmission cable
Rear panel terminal
Take care so that the earth (ground) cable does
not get into touch with other cables and parts.
Hole-A
Relay connector
Hole-B
Hole-A
+5V
GND
X1
X2
En-6