AirStage UTY-DTGGZ1 Installation Manual - Page 8
Browse online or download pdf Installation Manual for Controller AirStage UTY-DTGGZ1. AirStage UTY-DTGGZ1 9 pages. Touch panel controller
Print Page5. 6.
Installation method
▪
Install the switch box in advance to the wall to which the touch
panel controller is to be installed.
(1)
Installation procedure
Verify that the power supply cable and transmission cable are
wired to the switch box.
Peel the cable covering.
Decide the path the power supply cable and transmission cable are
to follow up to the terminals of the touch panel controller.
After passing the power supply cable and transmission cable
through the specifi ed holes of the installation plate, fi x the instal-
lation plate to the switch box using screws.
Adjust the tilt of the installation plate by installing the accessory
washers.
In addition, pass the power supply cable and transmission cable
through the wiring hole of the rear cover and fi x the rear cover
using the tapping screws (M4 x 8mm, 2 screws) supplied with the
installation plate.
Next, fi x the rear cover to the wall using the 2 accessory screws
(M4 x 20mm) and accessory washers.
Fix the cables at 2 places by cable ties.
Provide a surplus of 5mm or more from the end of the covering of
the cable and fi x the part which is fi xed by the cable ties.
Fix the power supply cable and transmission cable to their re-
spective terminal so that there is no mistake.
Fill the cable holes with putty in order to prevent small animals
from entering.
Insert the connector of the connection cable.
Close the front cover and rear cover. Align the claw of the bottom
of the front cover and fi t the top to the rear cover.
Tighten the 2 screws at the side of the main unit.
▪
When LAN cable is connected, wire as shown in the fi gure.
Installation plate
Power supply
cable
Screw
Washer
Screw
Touch pen tray
(a) Lan cable
(b) Lan terminal
(c) CF card
En-7
Transmission
Power supply cable
cable
Switch box
Hole in wall
LAN cable
Transmission
cable
Cable tie
Harness
Connection cable
Rear view
(a)
(b) (c)
▪
Detail description of power supply cable connection
Remove the screw.
Remove the power
supply terminal cover.
Power supply terminal cover
Connect the power
supply cable to the
power supply terminal.
Mount the power
supply terminal cover.
Then, take care that
the power supply cable
does not get caught in
the edge of power sup-
ply terminal cover.
Tighten the screw.
(2)
Installation of touch pen
Touch panel
controller
Hole for
strap
Strap
Touch pen
Screw
Power supply cable
Cable tie
Power supply terminal
Hole for
strap
There is a hole for a strap which
suspends the touch pen at the
main unit.
Use it so that the touch pen will
not be dropped or lost.
*
There are holes for a strap at
both sides of the main unit.
Install at the easiest hole to
use.