AirStage UTY-DTGG Installation Manual - Page 4
Browse online or download pdf Installation Manual for Touch Panel AirStage UTY-DTGG. AirStage UTY-DTGG 8 pages. Touch panel controller
Print Page▪
Installation layout
When installing the touch panel controller, installation
layouts such as these are not allowed.
Left-right sideways
Reversed installa-
installation prohibited
tion prohibited
51
INSTALLING THE TOUCH PANEL CONTROLLER
WARNING
Always use the accessories and specified installation
work parts. Check the state of the installation parts.
Not using the specified parts will cause fall, water leak-
age, electric shock, fire, etc.
Install at a place that can withstand the weight of the
unit and install positively so that the unit will not topple
or fall.
When installing this unit, make sure that there are no
children nearby. Otherwise, injury or electric shock
could result.
After this unit is installed, perform a test run to verify
that the device operates normally. Then describe the
operation method of this unit to the customer.
Install a circuit breaker. Not installing a circuit breaker
will cause electric shock or fire.
CAUTION
Before opening the case of this unit, remove all the
static electricity accumulated on the human body. It
will cause an accident.
When the front cover fixing screws are removed, be
careful that the front cover does not fall off. It will
cause an injury.
The circuit boards of this unit are at both the front
cover and rear cover. When a cover is opened, the cir-
cuit boards may be damaged by the screwdriver. This
will cause an accident.
The front cover and rear cover are connected by wir-
ing. When disassembling, be sure that the wiring is not
stretched.
Do not touch this unit's circuit board and circuit board
parts directly with your hands. Doing so may cause
electric shock or injury.
Tightening the mounting screws too tight will damage
the case of this unit.
When inserting the hooks, do not push them in unrea-
sonably. Doing so may damage or deform the claws.
Do not operate the surface of the touch panel with
other than the accessory touch pen or your finger. It
will scratch the surface and cause trouble.
51 11
▪
Make ready the touch panel controller.
Flat installation
Side view
prohibited
(1)
Remove the
both sides of the touch panel controller. (Fig. 1)
(2)
Separate the front cover part and the rear cover
part.
(3)
Hook your finger at the notched part indicated
by arrow and the rear cover and open in the
direction of arrow . (Fig. 1)
(4)
Connect the front cover and rear cover and
grasp and pull out the connector of the con-
nection cable. (Fig. 1)
Fig1
1
(5)
Remove the installation plate
2 places from the inside of the rear cover. (Fig. 2)
Fig1
2
Fixing screw
Wiring
hole cover
*
(6)
Installation plate dimensional drawing
Separate the installation plate from the rear
Installation preparations
Front view
screw at 2 places at the top of
Screw
Rear cover
Front cover
*
During work, be amply
careful so that the front
cover does not fall off.
Connection cable harness
Rear cover (Inside)
The fixing screws are used at installation. Do not lose
them.
Side view
Screw
fixing screws at
Fixing screw
Wiring
hole cover
En-3