AirStage UTY-DTGY Installation Manual - Page 8

Browse online or download pdf Installation Manual for Touch Panel AirStage UTY-DTGY. AirStage UTY-DTGY 8 pages. Touch panel controller

Print Page
Insert the connector of the connection cable.
Close the front cover and rear cover. Align the claw of
the bottom of the front cover and fit the top to the rear
cover.
Tighten the 2 screws at the side of the
@
power supply cable
Switch box
Hole in wall
Installation
plate
power supply
@
cable
Screw
Washer
Screw
Binder
Touch pen tray
(2)
Installation of touch pen
Touch panel controller
Hole for strap
Strap
Touch pen
main unit.
Transmission
cable
Transmission
cable
Binder
Harness
Connection cable
Hole for strap
There is a hole for a strap
which suspends the touch pen
at the main unit.
Use it so that the touch pen will
not be dropped or lost.
*
There are holes for a strap at
both sides of the main unit.
Install at the easiest hole to
use.
61

TURNING ON THE POWER

CAUTION
Check that the power supply voltage is within the
specified range. If a power supply voltage outside the
specification is input, it will cause trouble.
Recheck the wiring. Incorrect wiring will cause trouble.
After installation work is completed, check the following
contents:
Is touch panel controller
transmission cable wiring work complete?
Does the power supply match the rating of the touch
panel controller?
Turn on the touch panel controller
Since there is no power switch at the main unit, turn
on the power by means of the power distribution
panel.
If the following installer setting screen is displayed at
the screen of the touch controller panel, installation
work is complete.
For setting and operating of the touch panel controller,
refer to the separate operating manual.
*
Since there is some kind
of a problem when the
installer setting screen
does not appear, recheck
the work contents.
power supply cable and
main unit power.
En-7