ADVANCED FLOORTECH AF-X1 Operation Instructions Manual - Page 9

Browse online or download pdf Operation Instructions Manual for Scrubber ADVANCED FLOORTECH AF-X1. ADVANCED FLOORTECH AF-X1 13 pages. Floor scrubber

Print Page

AF-X1

according to the scrubbing conditions, and move the water volume adjustment handle up

and down. Control the flow of water to clean the ground. It can also reduce the

consumption of clean water (detergent). Start the switch, brush the motor. The solenoid

valve opens and the machine starts to work.

●Because of the uneven ground, sometimes after cleaning, there is still water, then the

brush plate can be raised and the water suction motor can be started. Push the scrubber

over the waterlogged area. Repeated, repeated absorption. If there are deep grooves on

the ground, it will affect the water absorption efficiency of the machine, so it can only be

dealt with separately.

Possible problems with squeegee adjustment:

When you feel that the motor of the water suction machine is suddenly abnormal during

use, and the squeegee cannot absorb water or the sound of the water suction machine is

abnormal, and the squeegee cannot absorb water, you should immediately stop the

operation and check.

①The water level has risen to the highest position, the floating ball rises to cut off the air

passage, and the method of discharging sewage: remove the sewage tank at a suitable

place, open the cover of the sewage tank, discharge the sewage into the sewer, and

wash the sewage tank.

②If the water level in the sewage tank is not high at this time, and there is no excessive

foam. Please check the connection between the squeegee and the pipe, it is very likely

that it is blocked by debris, and it will return to normal after cleaning;

③ If the water level in the sewage tank is not high at this time, but there is a lot of foam, it

means that you may have added too much cleaning solution or the cleaning solution you

are using is a high-foaming cleaning solution. Add an appropriate amount to the sewage

tank. It can be used normally after defoamer;

④If none of the above three situations are true, please unplug the suction tube on the

suction grill, turn on the suction motor, and try to see if the suction of the air inlet is normal

by hand.

Replacing the brush disk method

①Install the needle plate and put the brush plate to be installed under the brush plate

cover (if using a needle plate, please install the brush pad on the needle plate before

putting it in) Put down the brush plate so that the plate head and the brush plate bayonet