CARLO GAVAZZI SBPBASEB Manual - Page 11

Browse online or download pdf Manual for Accessories CARLO GAVAZZI SBPBASEB. CARLO GAVAZZI SBPBASEB 13 pages. Carpark base holder
Also for CARLO GAVAZZI SBPBASEB: Instruction Manual (4 pages)

Print Page
CARLO GAVAZZI SBPBASEB Manual
SBPBASEB mounting
Place the sensor with the vertical mark at the tip of the triangle base.
Turn the sensor clockwise until the vertical mark is positioned at the rear end of the triangle. The sensor is now
attached to the base.
Release the sensor by turning it anti-clockwise.
D+
D-
POW
Fig. 5 Basepart: mounted on the
ceiling
When mounting the SBPSUSxxx sensor on the ceiling, the sensor must be installed at an angle of maximum
± 5 degrees deviation from the ceiling surface.
Mount the SBPBASEB and the sensor (SBPSUSL45 only) with a maximum horizontal deviation of ±2 degree
to have the best performance in terms of signal reliability.
See drawing below.
Fig. 7 Maximum ±5° vertical deviation
Make sure that there is some extra wire for the sensor so that maintenance of the sensor/base in the future is
enabled. Also place the wire correctly to avoid damage to the cable isolation.
20/03/2019
SBPBASEB ENG
a
Fig. 6 Mount / Unmount
MAX ±5°
Fig. 8 Maximum ±2° horizontal
deviation. Bottom view
SBPBASEB
b
MAX ±2°
11
Carlo Gavazzi Controls S.p.A.