ANCEL AJ600 GDI Piezo Quick Start Manual - Page 12

Browse online or download pdf Quick Start Manual for Test Equipment ANCEL AJ600 GDI Piezo. ANCEL AJ600 GDI Piezo 14 pages. Injector cleaner & tester

Print Page

ANCEL

Select On-Vehicle Cleaning function, and set the cleaning time.

Press Run key to start the function, adjust the fuel pressure by pressing + or – keys.

Start the engine to begin cleaning.

Connecting

There are two cases for the line connection: one is the connection with fuel-return hose and the other is the connection

without the fuel-return hose.

Connection with fuel-return hose:

Disconnect the fuel supply hoses (C, D) and fuel return hoses (A, B) of the engine fuel system (when disconnecting

the fuel line connectors, cover them with towels). Choose proper connectors and connect them to the B end and C

end separately, and then connect the other ends to corresponding return hose and outlet hose of the device.

Connect the two other disconnected ends (A, D) with a proper hose, or remove the fuel pump fuse, or disconnect

the power cable of engine fuel pump.

1- Injector Cleaner & Tester; 2-Engine; 3- Fuel-return hose from engine; 4- Fuel-inlet hose to engine;

5-Auto filter; 6-Engine fuel supply hose; 7-Engine fuel return hose; 8-Fuel pump; 9-Fuel tank

Connection without fuel-return hose:

1) Disconnect the fuel supply hoses (E, F) of the engine fuel system (when disconnecting the fuel line connectors,

cover them with towels), and then choose a suitable connector, connect it to the E end and reconnect the fuel

outlet hose of the device. Hang the fuel return hose.

2) Block the other end of the disconnected end (F) with a stopper (for fuel pump with fuel return function only)

or remove the fuse of fuel pump or disconnect the power cable of engine fuel pump.

1- Injector Cleaner & Tester; 2-Engine; 3-Stopper; 4- Fuel-inlet hose to engine;

5-Fuel tank;6-Fuel filter; 7- Engine fuel supply hose; 8-Fuel pump；

Tidy up after cleaning

After the on-vehicle cleaning is completed, turn off the ignition switch of the vehicle. Restitute the hose

connection, start the engine and accelerate properly to check if there is any fuel leakage at the connectors or in

the hoses.

Please clean the fuel tank and the lines of the device with test solution at the end of the on-vehicle cleaning, the

specific procedures are: drain the detergent left in the fuel tank first and dispose it according to its cleanliness.

AJ600 GDI Piezo Injector Cleaner & Tester